Functions; Maintenance And Cleaning; Cleaning The Product; Cleaning The Filter - Silvercrest SLR 55 A1 Manual De Instrucciones

Functions

Timer function
You can select a delayed switch-off time with the
timer function.
W hen the product is switched on, press the timer
button until the LED for the desired operating
10
time lights up. The product will automatically
switch to standby mode after 1 / 2 / 4 or 8 hours.
Note: The product does not switch off after
the timer switching time has ended, but goes
into standby mode. After the timer switching
time has ended, press the ON / OFF button
to switch off the product.
Ioniser
P ress the ioniser button
is switched on. The respective LED will light up
and the product will emit negatively charged
ions into the ambient air through the purified
air, which will remove pollutants from the air.
Filter
After about 2000 hours of operating time, the filter
button will light up. This indicates that the filter
13
must be replaced.
Replace the filter as described in the chapter

"Replacing the filter".

Child safety lock
H old the filter button
pressed at the same time for three seconds when
the product is switched on. A beep will sound
when the child safety lock has switched on. The
ON / OFF button
12
now locked.
Note: If the filter button
are not pressed at the exact same time, the filter
button will flash three times. Child safety lock
13
has not been activated.
Hold the filter button
pressed for three seconds again when the child
safety lock is switched on. The beep sounds when
the child safety lock has been switched off.
Mode
P ress the option key
sired function lights up:
when the product
11
and option key
13 14
will flash. All buttons are
and option key
13
and option key
13 14
until the LED for the de-
14
Set-up / Maintenance and cleaning
Sleep mode: After pressing sleep mode, the
lighting on the device front will switch off after
approx. 10 seconds. Only the buttons on the
top of the device will light up in sleep mode. This
means that lighting will be kept at a minimum
during the night.
Turbo mode: The fans run at maximum speed.
Auto mode: The product will test the air quality
and - depending on the result - automatically
adjust ventilation when in this mode.
LED colour for air quality
green: good air quality
yellow: medium air quality
12
red: poor air quality

Maintenance and cleaning

A lways unplug the mains plug
mains socket before maintaining or cleaning
the product.

Cleaning the product

D o not use aggressive chemicals or scouring
agents.
C lean the housing with a soft, dry cloth.

Cleaning the filter

R emove the front cover
examine the condition of the HEPA / activated
carbon pre-filter
If dust or other impurities have accumulated,
remove the HEPA / activated carbon pre-filter
14
and wash it in a warm, soapy solution.
Then allow the HEPA / activated carbon pre-filter
to dry properly and replace it as depicted
6
in Figure C.
Replacing the filter (see Fig. C)
If the filter button
replaced. Proceed as follows:
R emove the front cover
:
9
from the
4
at regular intervals to
5
.
6
lights up, the filter must be
13
(see Fig. CI).
5
6
GB/MT 33