Channel Master Digital Advantage 100 Para El Usuario página 12

D. WALL MOUNT
Suggested Height Limit: 10 feet above rooftop.
If the roof overhang is not excessive, the side of the
house can be used for mounting. If a wall mounted
installation is done from the ground up, use a ground
mount with a "spike" at the ground. Position the wall
brackets over a stud if possible; one above the other
and space a minimum of three feet (3) apart. For
metal siding, mark mounting holes, then drill pilot holes
through the siding for mounting screws. If you use a
2-piece mast, assemble the pieces as shown, making
sure that they are properly locked together. Split
between masts should be between the two (2) wall
brackets, After the installation has been completed,
mount the extra WARNING LABEL supplied with the
antenna hardware to the mast at EYE LEVEL!
E. TRIPOD MOUNT
Use on peaked or flat roofs.
Suggested Height Limit: 10 feet above roof top.
The tripod mount can be mounted to any style roof
by adjusting the bracket on the center leg. Insert
the mast into the tripod mount and place the mount
with legs over the roof rafters. Make sure the mast is
vertical. Remove the protective covering from one
side of the three (3) pitch pads and place under the
base of each tripod leg with the tacky side towards
the roof. Secure the tripod mount to the roof using
lag screws. After the installation has been completed,
mount the extra WARNING LABEL supplied with the
antenna hardware to the mast at EYE LEVEL!
F. ANTENNA REMOVAL
Removal of your antenna should be exactly in reverse
of the installation instructions. For your own safety,
please follow the instructions for installing the antenna
starting with the last step first. This is the only way to
safely remove your antenna.
10
D IG IT A L A D V A N TA G E
a n t e n n a s er i e s
™