Bresser MyTime Bath Mini Manual De Instrucciones página 7

Tabla de contenido

Publicidad

dealer will contact the Service Centre and can send the device in to be repaired, if necessary.
Protect the device from severe shocks! The manufacturer is not liable for damage related to
improperly installed batteries.
START-UP/PoWER SUPPLy
1. Remove the cover from the battery compartment (5).
2 Insert a 1.5V AA/LR6 battery into the battery compartment (5). Pay attention to the correct
polar direction (+ / - ) of the battery as indicated inside the battery compartment.
SETTING ThE TImE
1. After inserting the battery, the movement works (hands move).
2. Turn the setting wheel (6) to set the correct time.
3. Put the cover back on the battery compartment.
hUmIDITy INDICAToR
The humidity indicator displays the following conditions:
WET
Wet. Indoor humidity between 66% and 100%
COMFORT Comfortable. Indoor humidity between 36% and 65%
DRY
Dry. Indoor humidity between 0% and 35%
ImPoRTANT!
Windows should be opened wide for a short time (a few minutes) for effective ventilation. If
possible, open windows on opposite sides of the apartment (full ventilation).
moUNTING/PoSITIoNING oF ThE CLoCK
There are 2 ways to mount this clock on the wall or on a flat surface:
A. Positioning on a table: Put the pins of the stand (4) into the holes in the housing's backside.
Position the clock on a flat surface (e.g. bathroom cabinet).
B. Slightly moisten the suction cups (3) and press the clock with the suction cups against a
flat wall surface.
Ventilation recommended.
-/-
Air humidification recommended.
DE
GB
7

Publicidad

Tabla de contenido
loading

Tabla de contenido