Descargar Imprimir esta página

Bushnell TROPHY CAM HD 119874 Manual De Instrucciones página 33

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

Photo", or with very short Interval settings, some images may appear darker
than others due to the quick response and rapid retriggering of the camera,
allowing less time for the flash to fully recharge before firing again.
d. Make sure "LED Control" in the setup menu is set to "High" to ensure
maximum output. Check that "NV Shutter" in the menu is set to "Auto" and not
"High", as higher shutter speeds can result in darker images.
e. The ARD (anti-reflective device) shield can be removed to maximize flash
output. See page 28 for more details.
2. Daytime photos or videos appear too dark
Make sure that the camera is not aimed at the sun or other light sources during
the day, as this may cause the auto exposure to produce darker results.
3. Night photos or videos appear too bright
If the subject is close to the camera (less than10ft/3m), change the LED
Control parameter in the Setup Menu to "Medium" or "Low". Set trigger Interval
to 2S or above.
4. Daytime photos or videos appear too bright
Make sure that the light sensor will not be in the shade (from tree leaves/
branches) while the camera lens is aimed into a bright area during the day.
5. Photos with streaked subject
a. In some cases with low lighting conditions and fast moving subjects, the 4K
or HIGH resolution settings may not perform as well as the HD setting.
b. If you have multiple images where fast moving subjects produce streaks on
the photo, try the HD setting instead.
c. Set Interval to 2S or above to reduce motion blur.
d. Set "NV Shutter" to "High" to minimize motion blur.
6. Red, green or blue color cast
a. Under certain lighting conditions, the sensor can become confused resulting
in poor color images.
b. If this is seen on a consistent basis, then the sensor may need servicing.
Please contact Bushnell customer service.
7. Short video clips—not recording to the length expected
a. Check to make sure that the SD card is not full.
b. Make sure that the camera has good batteries in it. Near the end of the
33

Publicidad

loading