Mobilex BOA BP 01072 Manual De Usuario página 3

Mobilex A/S
Grønlandsvej 5
DK-8660 Skanderborg
www.mobilex.dk
use the air pump as a toy.
•
Store the air pump in a secure location. If the air pump is not used for long periods of time, it should
be stored in a dry, locked space inaccessible to children.
•
Regularly check the cord of the charger. Never carry the charger by the cord and never pull the plug
out of the outlet by jerking the cord. Make sure that the cord is not exposed to hot objects, oil or
sharp edges.
• Keep the air pump clean to achieve maximum output and safety. Examine the plug, charger and
cord at regular intervals and have them repaired by an expert if they are damaged.
• Pull the charger plug out of the plug socket when the charger is not in use.
•
Never charge the battery outdoors.
•
Do not open the battery, only open the pump and remove the battery if the pump is scrapped.
•
Protect the pump and battery against impact. The pump should be stored in a dry, frost-free place.
• The battery and charger are designed for each other. Only use the original enclosed charger for
charging.
• Protect the pump against heat and fre: danger of explosion!
• Do not place the pump on a heater and do not expose it to solar radiation for a long period. It is
damaged at temperatures above 50° C. Allow hot batteries to cool of completely before charging.
• Stay alert. Always pay attention to what you are doing when working with the air pump.
Instructions
Always read the instruction manual before using the Cordless Air-pump for the frst time – it gives
instructions on how to make optimum use of the air pump and what precautionary measures should be
taken in connection with its use.
Your new cordless air pump has been specially designed for simple and efcient infation. The air pump
provides a small quantity of air at a relatively high pressure —this means that this air pump is not suitable
for infating large infatable objects requiring a large airfow at low pressure, such as air-mattresses,
infatable beach toys and infatable furniture.
Important - do not run the air pump for more than 10 minutes in continuous operation mode - and after 10
minutes allow it to cool for a minimum of 10 minutes.
Your air pump is equipped with a union valve (4). When you want to pump up an object, loosen the union
valve ( counter-clockwise ) and push it down over the valve on the object to be infated — if this cannot be
done, ft a suitable adapter. Tighten the union valve again ( clockwise ) and pump.
Loosen the union valve again before removing the air pump from the object or taking out the adapter.
Inflating Balls
Loosen the union valve (4) and press the Threaded end at a-ball adapter (5) into the union valve, lighten
the union valve again so that the ball adapter is secured.
Carefully push the pointed end of the ball-adapter into the ball's valve.
Then press the start switch (1) and pump.
Carefully remove the ball adapter from the ball.
Loosen the union valve again to remove the ball adapter from the union valve.
Inflating Bicycle Wheelchair Scooter
Loosen the union valve (4) and ft the pump onto the valve.
If the pump do not ft for the valve, ft a suitable adapter.
For bicycle valves with a French valve (typically racing bike), loosen the valve screw
only halfway before ftting the bicycle adapter onto the valve.
Tighten the union valve (4) again.
Then press the start switch (1) and pump.
Loosen the union valve (4) again before you remove the air pump from the tire valve
Accessories
The pump is equipped with 3 pcs adapter set (7);
Bicycle adapter, ball needle, balloon adapter and a short hose adapter.
Rev. 12/17 Page 3 of 16
a better life in motion
UM-260020-Multi