Replacing Old Rocker Switch; Attaching The Switch Latch - Power Probe BASIC Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Power Probe Basic

REPLACING OLD ROCKER SWITCH

Rocker Switch slots makes it easy to replace a worn out switch in
the field without having to send it in for repair.
Make sure to install the new
switch straight and press
until flush with casing.

ATTACHING THE SWITCH LATCH

Switch Latch (included) holds constant power or ground to your
circuit for many applications and dynamic testing.
Position the Switch Latch on top of the Rocker Switch. Make sure the (+)
sign is on the top and the slider is placed on neutral position. Insert one side
of the bottom edge into the slot then push and snap the other side of the
latch until you hear a click sound indicating that the switch latch has been
fully attached to the tool. Once installed, test the slider by pushing upward
and downward to make sure it was attached correctly.
To detach the latch, use a small screwdriver or any flat end pry tool. Insert
the tool into one of the slot and carefully apply a mild force by lifting the
switch from the case.
Remove the old rocker switch with a small
screw driver or any flat end pry tool. Insert
the tool into the slot and carefully apply a
mild force by lifting and popping out the
switch from the casing.
Slot
Switch Latch
Slider
www.powerprobe.com
Rocker Switch
(PN005)
800-655-3585
14

Hide quick links:

Publicidad

Capítulos

Tabla de contenido
loading

Productos relacionados para Power Probe BASIC

Tabla de contenido