Automatic Search Method - Steren RM-7 Manual De Instrucciones

1.- Switch your device on (not in Stand By).
2.- Aim the remote control at your device during the automatic search method.
3.- Press and hold SET button. Then press the corresponding key, to
program your desired device (TV, DVD, VCR, etc). The indicating LED turns on.
4.- Release the keys. Press the SET button once again. The indicating LED
will be blinking and the search begins.
5.- Press POWER (1) constantly -256 times max-, until your device turns off.
IF the equipment turns off, IMMEDIATELY release THE power (1) button.
6.- Press the button of the programmed device (TV, DVD, etc.). The remote
control store the code for your device and exit from Search Mode.
7.- Press Power (1) once again to check that your device turns on. Test
the remote control functions, it must to control almost the total of functions,
otherwise repeat the instructions.
Notes:
Be patient. If your device don't turn off after few tries pressing Power (1),
repeat from step 2.
Do not press different buttons as we mentioned in this instruction manual.
Do not exceed more than 30 seconds between each step. Otherwise the
remote control exit from the Search mode and you must to repeat from step 2.
10 10

Automatic search method