C5 Carton Contents; Fitting Your C5 In-Ear Headphones; Selecting Headphone Tips; Adjusting The Cable Loops - Bowers & Wilkins C5 Manual De Instrucciones

1. C5 carton contents

1. C5 in-ear headphones
2. Extra-small, medium and large ear tips
3. Storage pouch

2. Fitting your C5 in-ear headphones

Fitting your in-ear headphones correctly will
help ensure that their performance reaches its
full potential. First, identify the left and right
headphones. Identification legends are engraved
on the body of each one. This is illustrated in
Diagram 1.

2.1 Selecting headphone tips

The performance of your C5 headphones will only
be realised by using the ear tips that most closely
match the size of your ear canals. The headphones
are supplied with extra small, small (pre-fitted),
medium and large ear tips. Ear tips are removed
by gently pulling them away from the headphone
body and fitted simply by pushing them in to place.
Experiment with the ear tips to find the tightest seal
in your ear canals. Diagram 2 illustrates removal and
fitting of ear tips.

2.2 Adjusting the cable loops

Headphone fit can be adjusted by lengthening
or shortening the Secure Loop so that it presses
against the inner part of the ear to help retain the
headphone in place. This is illustrated in Diagram 3.

2.3 Removing the cable loops

If desired, your C5 headphones can be used without
the Secure Loop. To remove the loops, slide the
stopper down the cable, opening up the end of the
sleeve. Then pass the cable through the circular
slot on the side of the headphone until the thinner
section of cable enables its release. Reverse this
procedure to re-establish the loops. Diagram 4
illustrates removal and re-establishment of the
Secure Loop design cable loops.
Diagram 1
Left/right identification
Diagram 2
Removal and replacement of ear tips
Diagram 3
Using and adjusting the cable loops
Diagram 4
Removing and replacing the cable loops
3