Notes For Use; Electrical Connection; Safety Switch; Switching The Appliance On / Off - Profi Cook PC-EKM 1205 Manual De Instrucciones

Notes for Use

Electrical Connection

1. Check whether the mains voltage that you want to use,
corresponds with that of the appliance. You will find the
information about it on the rating plate.
2. Only connect the appliance to a properly installed safety
socket. The control lamp flashes 3 times.

Safety Switch

The appliance is equipped with a safety switch. It only works
if the container for the coffee beans is mounted correctly.

Switching the Appliance On / Off

NOTE:
The appliance cannot be switched on until a powder
volume setting has been selected.
• Press the button. The control lamp lights up continu-
ously. The grinding process begins.
• The grinding process finishes automatically.
• You can also finish the grinding process with the
button at any time.

Short-Term Operation

Only use the appliance in immediate succession for a max-
imum of 5 times. Allow the appliance to cool down for about
10 minutes before using it again.

Setting the Degree of Grinding

The grinder is gradually adjustable from extra fine to coarse.
Observe the symbols for setting the grinding degree. The
small dots mean a fine setting and the big dots a coarse
setting.
How fine or coarse you grind your coffee depends on
the further use of the coffee powder. The type of coffee
beans and the roasting process have an additional impact
on the taste. With a little practice you will find out which
grind setting is right for you. We can give you the following
indications:
Grind adjustment
Extra fine
Fine
Medium
Coarse
NOTE: Avoid blockages of the grinder
Set the grinding degree when the container for coffee
beans is completely empty or only during the grinding
process.
To change the grinding degree, slide the lever to the desired
setting.
32
PC-EKM1205_IM
Regulator for Setting the Powder Quantity (Number of
Cups)
Use the slider to set the amount of coffee that is to be
ground. Make sure that there are always enough coffee
beans in the container for coffee beans. Choose between
2 and 12 cups of coffee. The control lamp will flash.
The amount of coffee powder per cup depends on your
personal taste, the type of coffee and the grinding grade
setting.

Remaining Coffee Beans

Remove the coffee beans from the appliance if they are
older than a week. They have lost their aroma and diminish
the coffee taste.
1. Place the container for the coffee beans on the grinder.
2. Place the coffee grounds container with the lid in the
3. Adjust the desired degree of grinding with the lever.
4. Fill the coffee beans into the container. Do not overfill the
5. Place the lid on the container for the coffee beans.
6. Use the slider to select the number of cups for which you
Usage
7. Switch on the appliance with the
Espresso machine
Coffee machine
Hand filter
French Press coffee
8. When the grinding process is completed, the control
9. Disconnect the power supply from the socket when you
NOTE: Tip for espresso
Only grind the amount of coffee you are going to use
immediately.
TIP:
Store coffee beans in a sealed, air-tight container in the
refrigerator. That way, the coffee stays aromatic for longer.

Operation

CAUTION:
Before using the appliance, inspect the coffee bean con-
tainer for foreign matter and remove it.
Observe the symbols. Place the container with the sym-
bol above the symbol on the appliance. Turn the
container clockwise until it stops. It must audibly snap in.
motor housing until it stops.
container.
want to ground coffee powder.
lamp lights up continuously.
NOTE:
If you want to stop the grinding process prior to the set
time, press the button.
lamp flashes 3 times. Pull out the collecting container
with the coffee powder. Empty it.
are not using the appliance.
button. The control
29.10.19