Preparations For Use - REMS Helix VE Instrucciones De Servicio

eng
1.4. Speed, torque
Lo speed stage
Hi speed stage
Torque in lo speed stage
Torque in hi speed stage
1.5. Electrical data
REMS Helix VE
Li-Ion/Ni-Cd rapid charger
Li-Ion power supply
1.6. Dimensions
REMS Helix VE with battery
1.7. Weights
REMS Helix VE with battery 14.4 V, 1.5 Ah
Li-Ion 14.4 V, 1.5 Ah battery
Li-Ion 14.4 V, 3.0 Ah battery
1.8. Noise information
Emission at workplace
1.9. Vibrations
Weighted effective value of acceleration
The indicated weighted effective value of acceleration has been measured against standard test procedures
and can be used by way of comparison with another device. The indicated weighted effective value of accel-
eration can also be used as a preliminary evaluation of the exposure.
CAUTION
The indicated weighted effective value of acceleration can differ during operation from the indicated value,
dependent on the manner in which the device is used. Dependent upon the actual conditions of use (periodic
duty) it may be necessary to establish safety precautions for the protection of the operator.
2. Preparations for Use
2.1. Electrical connection
WARNING
Mains voltage present! Before connecting the REMS rapid charger, check whether the voltage given on the
rating plate corresponds to the mains voltage. On building sites, in a wet environment, indoors and outdoors
or under similar installation conditions, only operate the electrical device on the mains with a fault current
protection switch (RCD) which interrupts the power supply as soon as the leakage current to earth exceeds
30 mA for 200 ms.
Rechargeable batteries
NOTICE
Always hold the battery (8) upright when inserting it in the drive unit or the rapid charger. If inserted at an
angle it can cause damage to the contacts and result in a short circuit which damages the battery.
Total discharging by undervoltage
The Li-Ion batteries may not drop below a minimum voltage because otherwise the battery could be damaged
by "total discharge". The cells of the REMS Li-Ion battery are delivered pre-charged to approx. 40 %. There-
fore the Li-Ion batteries must be charged before use and recharged regularly. Failure to observe this regula-
tion of the cell manufacturer can lead to damage to the Li-Ion battery by total discharging.
16
0 – 300 rpm
0 – 1.250 rpm
31 Nm
13 Nm
14.4 V – ---
all-insulated, interference-suppressed
Input 230 V~; 50 – 60 Hz; 65 W
10.8 – 18 V – ---
Output
all-insulated, interference-suppressed
Input 230 V~; 50 – 60 Hz
14.4 V – ---; 6 A – 33 A
Output
all-insulated, interference-suppressed
190 × 210 × 82 mm (7.5" × 8.3" × 3.2")
1,3 kg (2,9 lb)
0,3 kg (0,6 lb)
0,5 kg (1,1 lb)
L = 68 dB L
pA
< 2,5 m/s²
= 79 dB K = 3 dB
WA
K = 1,5 m/s²