TFA Dostmann DIVA BASE Manual De Instrucciones página 50

transmitter at start-up and this code must be received and stored by the weather station in
the first 3 minutes of power being supplied to it.
SETTING UP:
When one temperature transmitter is used:
First, insert the batteries into the temperature transmitter (see "Install and replace
1.
batteries in the temperature transmitter" above).
2. Within 30 seconds of powering up the temperature transmitter, insert the batteries to
the weather station (see "Install and replace batteries in the weather station"
above). Once the batteries are in place, all segments of the LCD will light up briefly.
Then the indoor temperature and the time as 0:00 will be displayed. If they are not
shown on LCD after 60 seconds, remove the batteries and wait for at least 60
seconds before reinserting them. Once the indoor data is displayed, proceed to the
next step.
3. After the batteries are inserted, the weather station will start receiving data signal from
the temperature transmitter.
4. If the optional probe has been plugged to the dual channel transmitter, the outdoor
temperature should then be displayed on the weather station on channel 1 and 2.
Also, the signal reception icon will be displayed. If this does not happen after 2
minutes, the batteries will need to be removed from both units and reset from step 1.
49