Quick QCC-LCS TP Manual De Uso página 9

QCC-LCS TP - REV003A
OPERATION
The QCC-LCS TP interface connected to the power supply permits managing an RGBW system. The functions are activated
and the instructions are sent to the DMX512 output by means of a touch pad.
FUNCTIONS
1. COLOUR PANEL: The coloured panel is used to select the colour of the light to be associated to the zones (light zones)
by scrolling the coloured matrix using your finger.
2. ZONE CONTROL: The Z1/4 keys are used to manage up to 4 different zones. A zone may be on and enabled (blue light
next to the name), on but not enabled (light off next to the name), or off (orange light next to the name). If a zone is on and
enabled, the light zone associated can be modified. Slightly touch to enable the zone so that it can be modified; if you press
and hold, the zone is off and then on again.
3. ON/OFF: Briefly press this key to switch on/off all the four light zones.
4. STORE: This key is used to save a setting and then recall it. Select a colour and enable the zones where it is to be saved
and recalled; press and hold to save the setting (once setting is saved, the white light of the light zone in connection with
the zones enabled will flash). Briefly press to recall the setting saved in the zones enabled.
5. SCENARIO: This key is used to activate an automatic colour change scenario in the zones selected. Each time the key is
pressed the ten pre-set scenarios are enabled/ disabled one after the other. When the blue light next to the symbol is on,
this confirms one scenario is run.
6. BRIGHTNESS: This key is used to set the brightness of the light zones connected with the zones that are on and enabled.
Press and hold this key to reach the maximum and minimum brightness.
7. RGBW KEYS: These keys are used to switch on, off and dim each primary colour of the light zones of the enabled zones.
8. WHITE COLOUR CONTROL: This key is used to manage the WHITE channel setting over the active colour in the light
zones of the zones that are on and enabled.
QCC-LCS TP USER INTERFACE CONNECTIONS (Refer to the instructions on page 17 of this manual)
MAINTENANCE
The device requires no special cleaning procedure. Clean the front using a damp cloth, avoiding corrosive substances.
Do not apply liquids directly on the unit; they might penetrate and damage the device.
DISCONNECT THE POWER SUPPLY BEFORE CLEANING THE UNIT.
WARRANTY
Failure to comply with the prescriptions below will void the Warranty.
TECHNICAL DATA
MODEL
INPUT CHARACTERISTICS
Power supply
Power consumption
Control output
GENERAL CHARACTERISTICS
Operating temperature
Storage temperature
Relative humidity
Housing protection
Certifications
QUICK SPA
OPERATION / MAINTENANCE / TECHNICAL DATA
QCC-LCS TP
10 ÷ 30 Vdc
30mA
DMX512
from -20°C to +60°C
from -40°C to + 70°C
80% senza condensa
IP 40
CE marking
9
In case of discordance or errors in translation between
F
the translated version and the original text in the Italian
language, reference will be made to the Italian or English
text.
Quick ® reserves the right to modify the technical characte-
F
ristics of the equipment and the contents of this manual
without prior notice.
EN