Publicidad
Idiomas disponibles
Idiomas disponibles
ADJUSTMENTS
INSTALLING CHISEL & BIT
1. Loosen lock screw, shown in Figure 2.
2. Insert chisel bushing (with the hole facing forward) into the head. Tighten the screw just
enough to hold the chisel in place.
!
NOTE: Set the slot in the side of the chisel to the left or right, NOT to the front or back. This will
allow chips to escape when cutting mortises.
3. Push the chisel up as far as possible into the head. Then lower the chisel approximately
0.8mm to 1.6mm, depending on the type of wood being worked. Tighten the screw
to hold chisel in place.
4. Push bit up through the chisel opening as far as it will go. Lock the drill bit in place with the
chuck key.
5. Loosen screw and push chisel up against the bushing, then tighten screw. This should provide
the proper distance between the points of the chisel and the bit.
WORK STOP
The work stop can be mounted to the table , as shown in Figure 3. It is tightened into place .
６
EN
Publicidad
