Operation; Checking The Battery Charge Level - Remington RM4000 Manual Del Operador

WARNING:
Do not expose power tools to rain or wet
conditions.

CHECKING THE BATTERY CHARGE LEVEL

1. Press the charge meter button (Fig. 13).
2. One or more of the charge meter lights should illuminate (Fig.
13). The number and color of the lights will indicate the current
battery charge level:
• 3 Green Lights = 66 - 100% Charge
• 2 Green Lights = 33 - 66% Charge
• 1 Green Light = 1 - 33% Charge
• 1 Red Light = 0% Charge
3. If the red light illuminates, charge the battery before any further use.
NOTE: While in use, lithium-ion batteries provide power with
minimal power fade. When the battery is fully discharged, it will
immediately cut power to the unit and require charging.
HOLDING THE UNIT
WARNING:
Always wear eye, hearing, hand, foot and body
protection to reduce the risk of injury when operating this unit.
Wear a face mask or dust mask if the operation is dusty.
• Stand in the operating position (Fig. 14). Stand up straight. Do
not bend over.
• Keep feet apart and firmly planted.
• Hold the shaft grip with the right hand. Keep the right arm
slightly bent.
• Hold the handle with the left hand. Keep the left arm straight.
• Hold the unit at waist level.
• Position the cutting head a few inches above the ground.
ADJUSTING THE TRIMMING LINE LENGTH
This unit is equipped with a bump head. Trimming line can be
released from the cutting head without stopping the motor.
To release more line, lightly tap the bump knob on the ground (Fig.
15) while operating the unit at high speed. For best results, tap the
bump knob on bare ground or hard soil.
NOTE: Do not rest the cutting head on the ground while the unit is
running.
Each time the bump knob is tapped, about 1.5 inch (38 mm) of
trimming line is released.
NOTE: Always keep the trimming line fully extended. Line release
becomes more difficult when the cutting line gets shorter.
A blade in the cutting head shield will cut the line to the proper
length if any excess line is released.
CAUTION:
Do not remove or alter the line cutting blade
assembly. This may lead to serious personal injury or
damage to the unit.

OPERATION

Charge Meter Button
13
1% - 33%
33% - 66%
66% - 100%
Fig. 13
Fig. 14
Bump Knob
Fig. 15
0%