Resetting Thermal Protection - Waring Commercial MMB145CE/K Manual De Instrucciones

SToP. For momentary operation, press the PULSE
button. Motor will run on hI speed until the button is
released. Green LED light will blink while in operation.
NoTE: This blender utilizes a Slow Start
beginning hI or Lo operation, the unit will start in a lower
speed for 3 seconds and then switch to the full selected
speed. PULSE utilizes a 1-second Slow Start
for a more even blending of ingredients in container.
8. Allow motor to come to a complete stop before
removing container from blender base. Never place
the container on the motor base or remove it from
the motor base while motor is running.
9. Always hold container with one hand when starting and
while blending. Never operate without jar lid.
10. Wash and dry container after each use. See Cleaning
and Sanitizing Instructions.
11. Unplug to turn off all power to blender.

RESETTING THERMAL PROTECTION

• Your blender is equipped with a manual reset switch to
protect the motor from overheating.
• If your blender stops running under heavy use, or if the
green LED light starts to blink much more rapidly than
during normal blending, press the power switch to SToP
and unplug the power cord. Empty the blender container
of all its contents and allow approximately 5 to 10 minutes
for the motor to cool down.
• Plug the power cord back into the outlet and continue
blending.
• If your blender does not function properly following this
procedure, discontinue use and contact a certified Waring
Customer Service Center.
feature. When
™
8
. This allows
™