Turning The Light On And Off; Standard - Economic -Sleep Modes; Filtering Cycles; Protection Against Freezing - Astralpool SPA 4DREAM Manual De Funcionamiento

UTILIZATION MANUAL
ATTENTION!
Do not to forcibly turn the outer ring of the
jet, as you could damage it.

5.5. TURNING THE LIGHT ON AND OFF

To turn the light on and off, press
control panel.
The light will automatically disconnect after 4 hours.
ATTENTION! - Do not turn on the light when
the Spa is empty of water. The lamp will fuse
through lack of refrigeration.
5.6. STANDARD – ECONOMIC - SLEEP MODE
The mode is necessary to personalize and/or choose
the best functioning depending on our preferences.
Press "TEMP" and "LIGHT" to change the mode.
Standard Mode
It is programmed to maintain the wanted temperature.
Attention: On screen we will see the temperature of
the last time that the filtering pump was working for at
least 2 minutes.
When changing to standard, the message "
on screen.
Economic Mode
The Spa water is heated only within the filtering
cycles.
Ec
The message " " will
temperature is not the current one. In the event the
temperature of the water from the Spa gets the
Light
from the
+
SE
" is seen
be shown when
required temperature, the message "
with the temperature number.
Sleep Mode
This mode heats the water from the Spa 10ºC under
the programmed temperature and only during the

filtering cycles.

5.7. FILTERING CYCLES
The Spa has a filtering system for the solid impurities
of water. Water is collected by the filtering cartridge,
going through the filtering pump and the heat
exchanger, and returns into the Spa through all
impulsion nozzle.
When initiating each cycle of filtration, all the pumps
start up automatically during a short period of time to
recirculate all the suspended water of the pipes.
The first filtering cycle starts 6 minutes after the Spa is
connected to the power supply.
The second filtering cycle starts 12 hours later.
The length of the filtering cycle can be programmed
for 2, 4, 6 8 hours or continuous filtering (24 hours)
indicated as "
can choose between:
FC
= 24 hours filtering
F2
= 2 hours filtering and 10 hours stopped.
F4
= 4 hours filtering and 8 hours stopped.
F6
= 6 hours filtering and 6 hours stopped.
F8
= 8 hours filtering and 4 hours stopped.
The default filtering time is 2 hours (
For filtering time press "TEMP" y then "JETS".
Press "TEMP" again to adjust and then press "JETS" to
exit programming mode.

5.8. PROTECTION AGAINST FREEZING

In the event the temperature sensors detect a drop of
temperature below 7ºC, the resistance and the
filtering pump will connect automatically to prevent
the
the water from freezing as this could damage your
Spa.
7
Ec
FC
". To select the filtering program you
+
EN
" will be shown
F2
).