Macrom 44.05 Manual De Instrucciones página 11

SETTINGS AND SELECTORS
OUTPUT MODE SELECTOR WITH 2 INPUT CHANNELS AND A BY-PASS OUTPUT
a) "2CH " "4CH
INPUT OUTPUT
outputs select the position "2CH" and connect the outputs to the amplifier inputs marked with the
letters A / E (left) and B / F (right). Then select the position "4CH" in order to have 4 output
channels, A, B, C and D, respectively, to drive 4 speakers. You can then activate (ON) the
different sections of the built-in electronic crossover to obtain the High-Pass outputs A and B and/
or the Low-Pass outputs C and D.
NOTE: In case a preamplified output is needed to control another amplifier, the RCA-connectors
C and D marked BY-PASS and carrying a unitary gain output signal can be used.
The By-Pass output is active only with the "2CH
IMPORTANT NOTE: Both input sensitivity adjustments are activated and operate independently
on the respective outputs.
BY-PASS
0.5V
A / E C
0.1V
2 V
B / F
D
GAIN
CONTROL
b) "2CH " "3CH
INPUT
multi-amplifying system. There are 3 output channels, 2 stereo channels A and B, and a third
channel F with a single bridged mono signal.
In case you want to use the built-in electronic crossover, the outputs A and B can be connected
to medium-high speaker systems by placing the High-Pass selector in the ON position , whereas
by placing the Low-Pass selector in the position ON a woofer system or a powerful subwoofer
can be connected to the mono output F.
IMPORTANT NOTE: Both input sensitivity adjustments are activated and operate independently
on the respective outputs.
BY-PASS
0.5V
A / E C
0.1V
2 V
B / F
D
GAIN
CONTROL
c) "2CH " "2CH
INPUT
powerful 2-channel stereo system with the output channels E and F.
On activating the built-in electronic crossover, Low-Pass ON with this configuration, only the low
frequencies are output for driving two powerful subwoofers.
IMPORTANT NOTE: With this configuration only one of the two input sensitivity controls (the
right one) is activated for the adjustment of the signal at the E (left) outputs.
BY-PASS
A / E
0.5V C
0.1V
2 V
B / F
D
GAIN
CONTROL
" MODE: As your head unit is equipped with only two pre-amplified
4CH 2CH OFF
0.5V
INPUT
OUTPUT
0.1V
2 V
GAIN
CONTROL
4CH 3CH 2CH OFF
" MODE: This configuration uses a single 44.05/44.07 amplifier as a
OUTPUT
4CH 2CH OFF
0.5V
INPUT
OUTPUT
0.1V
2 V
GAIN
CONTROL
4CH 3CH 2CH OFF
MODE: This configuration uses the amplifier as a traditional and
OUTPUT
4CH 2CH OFF
0.5V
INPUT
OUTPUT
0.1V
2 V
GAIN
CONTROL
4CH 3CH 2CH OFF
" configuration.
INPUT
O N
E
+
A -
+
+
LOW PASS
HIGH PASS
O N
LEFT RIGHT
O N
E
+
A - +
+
LOW PASS
HIGH PASS
O N
LEFT RIGHT
O N
E
+
A -
+
+
LOW PASS
HIGH PASS
O N
LEFT
13
F
- +
B - C - D
+
+
- F
+
B - C - + D
+
F
- +
B - C - D
+
+
-
-
-
-
-
-