Teac A-H300mkII Manual Del Usuario página 9

A POWER
Press this switch to turn the unit standby or off.
The equipment draws nominal non-operating power from
the AC outlet with its POWER switch in the OFF position.
B STANDBY/ON
When the POWER switch of the main unit is depressed, use
this button to turn the unit on or standby.
The standby indicator lights when the unit is in the standby
mode. When the unit is turned on, it goes off.
C
CD DIRECT
Use this button to turn on or off the CD direct function.
When the CD direct function is on, the sound input from the
CD jack bypasses the BASS, TREBLE and BALANCE control.
The indicator lights when the CD direct function is on.
D VOLUME
Turn this knob (or press the VOLUME buttons of the remote
control unit) to adjust the volume.
E INPUT SELECTOR
Use this knob (or buttons of the remote control unit) to
select a source.
F REC SELECTOR
Use this knob to select a source to be recorded.
Select "OFF" when it isn't in use.
G
BALANCE
Use this knob to adjust the balance of the speakers.
Normally, set the knob to the center position.
H
Remote Sensor
When operating the remote control unit, point it towards the
remote sensor.
I
TREBLE
Use this knob to adjust the level of high frequency sound
range.
J BASS
Use this knob to adjust the level of low frequency sound
range.
K PHONES
For private listening, insert the headphones plug into this jack,
and adjust the volume by turning the VOLUME knob.
a
STANDBY
When the POWER switch of the main unit is depressed, use
this button to turn the unit standby.
b ON
When the POWER switch of the main unit is depressed, use
this button to turn the unit on.
c
Buttons for the operation of TEAC R-H300mk
d Buttons for the operation of TEAC T-H300DABmk
T-H300mk (TUNER).
@
< Following buttons work on the T-H300DABmk@ only. They
don't work on T-H300mk@:
FUNCTION/FM MODE, AUTO TUNE, ENTER, INFO
e
Buttons for the operation of TEAC PD-H300mk
f FL DIMMER
When the T-H300DABmk
remote control cord, use this button to dim the display of T-
H300DABmk /T-H300mk
@ @
< The T-H300DABmk /T-H300mk
@
function.
g
Numeric buttons
Use these buttons to select a track number or a preset
channel.
Press the CD or TUNER button to select the component to be
operated, and then press the numeric buttons.
(Even when the CD or TUNER button is pressed without
pointing at the main unit, the selection of the remote control
unit will be changed.)
For instance, to select track number 35, first press the CD
button, and then press "3" and "5".
To select numbers less than 10, press "0" and then the
number. As an example, to select number 5, press "0" and
"5". (Optionally, you may press just the number "5" and
then wait a few seconds.)
h SLEEP
Use this button to set sleep timer.
< The T-H300DABmk /T-H300mk
@
function.
Note:
< To simplify explanations, instructions refer to names of
buttons and controls on the front panel, making no mention
of the use of remote control unit.
(TAPE).
@
or
@
(CD).
@
/T-H300mk is connected by a
@ @
, R-H300mk , and PD-H300mk
@
is indispensable for this
@
is indispensable for this
@
.
@
9