Dpt 70 Bodypack Transmitter; Ck 55 L Lavalier Microphone; C 544 L Headset Microphone; Putting On The Microphone - Harman AKG DMS 70 Modo De Empleo

Microphone technique

DPT 70 bodypack transmitter

34

CK 55 L lavalier microphone

Fix the microphone to the supplied lavalier clip or to the optional H 41/1 tiepin.
1) Clip the microphone onto the speaker's clothing, as close as possible to his or her
mouth.
The closer the microphone is to the speaker's mouth, the less danger there is of feedback.
NOTE
2) Make sure to aim the microphone towards the user's mouth.

C 544 L headset microphone

Putting on the microphone

1) Put the microphone on.
2) Bend the gooseneck so that the microphone sits to one side in front of the corner of your
mouth.
• If you hear excessive pop noise ("p" and "t" sounds are overemphasised unnaturally),
move the microphone capsule further away from your mouth (back or down).
• If the microphone sounds "thin" or flat, move the microphone capsule closer to your
mouth.
NOTE
• Find the optimum position during the soundcheck.

Windshield

If (for instance,on an open-air stage) excessive wind or pop noise becomes audible, attach the
supplied foam windshield to the microphone.
1) Slide the windshield onto the microphone capsule.
2) Pull the windshield over the outer end of the microphone capsule.

Moisture shield

A special moisture shield on the microphone capsule makes it harder for moisture and
makeup to penetrate into the microphone.
This prevents the microphone apertures from being clogged by perspiration or makeup, which
would make the sound dull and reduce the sensitivity of the microphone. Therefore, you
should never remove the moisture shield from the microphone.
The C 544 L headset microphone includes a replacement moisture shield in case the first one
gets damaged or lost.
DMS 70 DMS 70 DMS 70 DMS 70