Guided Tour - Cr77 Rear Panel - Samson CONCERT 77 Manual De Instrucciones

Guided Tour - CR77 Rear Panel

Using the strain relief: Gather up a loop of wire and pass it through the strain relief,
then pass the adapter plug through the loop in order to create a knot.
1: DC input - Connect the supplied 12 volt 160 mA power adapter here, using the strain relief as
shown in the illustration below. WARNING: Do not substitute any other kind of power adapter;
doing so can cause severe damage to the CR77 and will void your warranty.
2: Balanced output* - Use this electronically balanced low impedance (600 Ohm) XLR jack
when connecting the CR77 to professional (+4) audio equipment. Pin wiring is as follows: Pin 1
ground, Pin 2 high (hot), and Pin 3 low (cold).
3: Audio Output Level switch - Sets the audio output level attenuation of the balanced output
(see #4 below) to -20 dBm (line level) or -40 dBm (mic level). See the "Setting Up and Using the
Concert Series System" section on page 8 in this manual for more information.
4: Unbalanced output* - Use this unbalanced high impedance (5K Ohm) 1/4" jack when con-
necting the CR77 to consumer (-10) audio equipment. Wiring is as follows: tip hot, sleeve ground.
* If required, both the unbalanced and balanced outputs can be used simultaneousl
Concert Series Frequency Conversion Chart
�������
��
��
��
��
��
��
2
1
����������� �������
������� ���
������� ���
������� ���
������� ���
������� ���
������� ���
4
3 4
-
�����������
�� ������� ���
�� ������� ���
�� ������� ���
�� ������� ���