Radio Operation; Bass Boost Operation; Playing Phono Records - Nevir NVR-800VMUC Manual De Instrucciones


The recommended effective distance for remote operation is about 10-15 feet.
1. Slide the FUNCTION Selector (12) to the "TUNER" position.
2. Slide the BAND Selector (11) to either FM or FM ST (FM Stereo Mode).
3. Rotate the TUNING CONTROL (10) until you reach the radio station you wish to listen
to. The radio station frequency shows on the LCD DISPLAY.
4. Adjust the sound level by rotating the VOLUME CONTROL (23).
5. To turn off the radio, Slide the FUNCTION Selector (12) to the "OFF" position. The
LCD DISPLAY will go "off".
FM STEREO RECEPTION
1. With the BAND Selector (11) in the "FM ST" position, the FM Stereo Indicator "
will light up when listening to a strong station that is broadcasting in "Stereo".
2. Slide the BAND Selector (11) to the FM position if the FM stereo reception is weak.
The reception may improve, but the sound is now monaural (MONO).
TIPS FOR BEST RECEPTION
FM – During FM reception, always keep the FM Wire Antenna fully extended. If FM
reception is weak try repositioning the FM Wire Antenna until you find the strongest
FM signal.
To enhance the low frequency sound, press the BASS BOOST BUTTON (13) once (button
in) to activate. Press the BASS BOOST Button (13) again (button out) to turn the Bass
Boost off.
Note:
Please refer to the ON/OFF graphic on the Front Panel for correct operation of the Bass
Boost function.
1. Raise the Turntable Dust Cover.
2. Remove the stylus protector and release the Tone Arm Clamp (6).
3. Slide the Function Selector (12) to "PHONO".
4. Place a record on the turntable, over the center spindle.
5. Set the Speed Selector Switch to 33, 45 or 78 rpm according to
the record you are playing. Place the included 45 RPM adaptor (2) over the center
spindle when playing 45 rpm records.
6. Move the Tone Arm to the beginning of the record or to the beginning of a particular
track. Gently lower the Tone Arm onto the record to start playing. Adjust the Volume if
needed. The Turntable will stop automatically when the record finishes.
7. To stop the record before it ends, lift the Tone Arm (4) using the Cue-lever (3) and
return it carefully onto the Tone Arm Clamp (6).
8. Replace the stylus protector on the stylus when not in use.
NOTE:

RADIO OPERATION

BASS BOOST OPERATION

PLAYING PHONO RECORDS

4
"