Bosch GCO 2000 Professional Instrucciones De Servicio página 2

1
2
3
4
5
6
7
8
9
A
17
18
19
Robert Bosch Ltda.
| 3 4 |
B
16
15
15
14
14
13
12
11
10
C
12
7
13
F 000 622 257 | 03.2008 F 000 622 257 | 03.2008
18
22 23 24
20 21
D
11
10
25
2
Robert Bosch Ltda.
Operating instructions
Working Instructions Guide the tool arm 3 slowly upward and tighten
the locking nut 5.
Maximum Work Piece Dimensions [mm]
Maintenance and service
Miter Angle
Work Piece Form 0° 45°
Maintenance
Should the machine fail in spite of careful man-
130 Ø 110 Ø
ufacturing and testing p roced ures, have the
repairs performed by an authorized customer
120 x 120 90 x 90
service location for Bosch electro_tools.
For inquiries and spare parts ordering, please
include the 10-digit order number on the name-
180 x 85 100 x 80
plate of the machine.
Always keep the machine and the ventilation slits
140 x 140 90 x 90
clean for efficient and safe working. When work-
ing with metal under extreme conditions, conduc-
tive dust can be deposited on the interior of the
Protect the cutting disc against impact and shock.
machine. In such cases, frequently blow out the
Do not subject the cutting disc to lateral pressure.
machine through the ventilation slits and connect
Do not load the machine so heavily that it
by means of a fault current circuit breaker (FI).
comes to a standstill.
The pendulum protective hood must always be
Advancing too fast considerably reduces the
able to move freely and close by itself. There-
performance capabilities of the machine and
fore, always keep the area around the pendu-
shortens the service life of the cutting disk.
lum protective hood clean.
The cutting disk becomes very hot while work-
ing; do not take hold of it until it has cooled.
Guarantee
Use only cutting disks that are suitable for the
We guarantee Bosch appliances in accordance
material to be worked.
with statutory/country-specific regulations
Depth stop (proof of purchase by invoice or delivery note).
Damage attributable to normal wear and tear,
As delivered, the depth stop 4 is set so that a new
overload or improper handling will be excluded
355 mm cutting disk does not touch the base plate
from the guarantee.
when sawing. To compensate for the wear of the
cutting disk, the depth stop can be set deeper. In case of complaint please send the machine,
undismantled, to your dealer or the Bosch
With the use of a new cutting disk, the depth
Service Center for Electric Power Tools.
stop must then always be set back to the origi-
Warning!
nal position.
Always adjust the depth stop so that the Freight and insurance costs are charged to the
cutting disk does not touch the base client, even for warranty claims.
plate when sawing.
Adjusting the Depth Stop Environmental protection
Before all work on the machine, pull the
Recycle raw materials instead of disposing as waste.
power plug.
The machine, accessories and packaging should
Loosen the locking nut 5 with the open-end
be sorted for environmental-friendly recycling.
wrench 8 (13 mm) provided. Swing the tool arm 3
The plastic components are labelled for catego-
with the handle 1 to the desired position.
rized recycling.
Screw the depth stop 4 in the clockwise or
counter clockwise direction until the bolt head
Subject to change without notice.
rests on the housing.
Robert Bosch Ltda.
en | 25
F 000 622 257 | 03.2008