Using Thread Spindle - EASYHOME MS-201 Manual Del Usuario

5. Bring thread over and across the Tension Adjusting Screw (3), positioning
thread between the 2 washers behind the tension adjusting screw. This is
what provides the lock stitch tension to the thread.
6. Pull thread from the Tension Adjusting Screw (3) guide through the 2
Guide (4) pulling thread from right to left.
7. Pull thread through the Take Up Lever (5) inserting thread from right to left.
8. Pull thread downward through 3
top down.
9. Pull thread downward through 4
10. Insert thread through eye of the Needle (8) from left to right, using the needle
threader if necessary. If needed, adjust the needle to reach the eye by turning
the hand wheel slightly clockwise (in the direction away from you).
Note: To use the needle threader, push the wire together and place needle
threader through the eye of the needle from right to left. Insert the thread
through the eye of the needle threader. Holding onto the needle threader
near the wire, pull the needle threader out of the needle, guiding the thread
through the eye of the needle.
11. Raise the Presser Foot by lifting up on the Presser Foot Lever located at the
back of the machine.
12. Pull about 5 inches of thread through the needle. Pull thread between the
presser foot and lay on the deck under the presser foot, running it in the
direction away from you.

Using thread spindle:

Note: When threading machine, use above numbered image for reference.
1. Raise Thread Spindle by grasping the notch on the top of the spindle and
pulling upward until thread spindle is fully extended.
2. Place thread spool on the Thread Spindle (1B).
3.
Pull thread from the spool on the Thread Spindle (1B) and put it through the
st
1 Thread Guide (2) pulling thread from right to left.
12
rd
Thread Guide (6) and insert thread from the
th
Thread Guide (7).
User instructions
nd
Thread