Assembly - Delta DP350 Manual De Instrucciones

UNPACkINg AND CLEANINg
Carefully unpack the machine and all loose items from the shipping container(s). Remove the rust-preventative oil from
unpainted surfaces using a soft cloth moistened with mineral spirits, paint thinner or denatured alcohol.
Do not use highly volatile solvents such as gasoline, naphtha, acetone or lacquer thinner for cleaning your
machine.
After cleaning, cover the unpainted surfaces with a good quality household floor paste wax.
For your own safety, do not connect the machine to the power source until the machine is
completely assembled and you read and understand the entire instruction manual.
1. Attach the column (A) Fig. 1 to the base (B) with the
four screws, three of which are shown at (C). Loosen
the set screw (D) and remove the ring (E) and the
raising rack (F).
2. Place the worm gear (G) Figs. 2 and 3, in the table
bracket (H).
Fig. 2

ASSEMBLY

ASSEMBLY TOOLS REQUIRED
3mm Hex Wrench
5mm Hex Wrench
Plastic Mallet
ASSEMBLY TIME ESTIMATE
Assembly for this machine takes less than 1 hour.
g
H
E
C
B
H
7
D
F
A
C
Fig. 1
g
Fig. 3