Inspection And Cleaning - PATONA BLUE E-Scooter PT13-1 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 42
6.2 Warnings
• Improper handling of the battery can lead to serious accidents. It can be danger for life and limb.
It is therefore essential to read and note the warnings.
• Do not use the battery if substances leak from the battery. Look for a doctor if you come into
contact with substances from the battery.
• Do not use the battery if you notice strange smells or heat.
• The battery, the E-Scooter and the charger are not suitable for small children.
• Do not open or disassemble the battery.
• Use only the supplied and approved accessories for charging.
• Dispose the Li-Ion battery properly, if it is defective or no longer performs. Batteries do not
belong in household waste.
6.3 Storage
• Charge the battery / E-Scooter to approx. 90% before storage.
• Recharge the stored battery / E-Scooter every 3 months.
• Make sure that there is no short circuit during storage.
• Protect the battery / E-Scooter from moisture and dirt.
• Store the battery / E-Scooter in a dry environment.
• If the battery is stored very cold (below 0 ° C - 5 ° C), please allow the battery /
E-Scooter to acclimatise at room temperature for approx. 24 hours before charging.
7. Charging your E-Scooter
1. Make sure the charging port is clean and dry.
2. Connect the charger to the socket (100-240V; 50-60Hz).
Make sure that the LED on the charger is green.
3. Connect the charging cable to the charging port of the E-Scooter.
• The indicator light on the charger should light up RED to indicate that your
E-Scooter is now charging.
• If the RED indicator light on your charger changes to GREEN, your E-Scooter is fully
charged.
• A full charge usually takes 4-5 hours.
4. 4. If the battery is charged, please disconnect the charger from the E-Scooter and the socket.
8. Inspection, Maintenance
Your E-Scooter must be cleaned, checked and serviced regularly.

8.1 Inspection and Cleaning

• Check the E-Scooter regularly for damage and wear.
• Check the body of the E-Scooter for stability and deformation.
• Check the tires for damage and wear.
• Use only a damp cloth and mild detergent to clean the E-Scooter. Too much moisture and / or
harsh detergents can cause damage.
• Dry the E-Scooter thoroughly after cleaning.
17

Publicidad

Tabla de contenido
loading

Tabla de contenido