Telcoma Automations FOX Serie Manual De Instrucciones página 33

GB
STANDARD PROGRAMMING
For correct, easy programming, it is essential that the following instructions
are followed to the letter.
1. Preliminary operations
- Set a code, as desired, in the FOX remote controls.
- Connect an antenna tuned to the antenna terminal on the receiver.
Alternatively, diminishing the receiver specifications, a piece of wire
approx. 20 cm long may be connected.
- Once the receiver has been connected to the control unit or the
necessary connections on to the terminal board have been completed,
switch on.
- As soon as the receiver is powered, it carries out an internal test, shown
by LED L2 coming on for 3 seconds.
2. Self-memorisation
- Upon pressing key P1 for an instant the relative led will blink 5 times.
- Within this period of time, transmit with the radio control required for use.
- Fixed indicator lights lasting about 3 seconds indi-
cate that the code has been successfully stored.
- Immediately after this the led starts blinking again,
waiting for a new radio control signal to be
memorised; if it receives none after blinking another 5
times, the receiver automatically exits from the programming stage.
Our transmitter and receiver are already operative!
- Follow the same procedure also for the other P keys.
3. Meaning of the blinking LEDs
- L2 on for 3 seconds: as soon as the receiver is powered.
1
L1 P1
-
.
-
33