Continuous Playback - Teac W-860R Manual Del Usuario

Playback
Playback with TAPE I or TAPE Il
1. Press the POWER switch.
2. Set the REV MODE switch to the required tape travel
mode.
Ä: One Side Playing
Ë: SideA ∑ SideB ∑ Stop
ï
ä: ∑ SideA ∑ SideB
Ë
ä
The tape will stop after 5 cycles.
3. Load a pre-recorded cassette tape in TAPE I or II.
4. Select the appropriate DOLBY NR system.
5. Press the Ó or Á button of TAPE I or II to start
playback.
6. Adjust the volume with the amplifier's volume control.
... To stop playback, press the STOP button.
Pitch Control ( TAPE I only )
Using the Pitch Control knob, the pitch (tape speed) of TAPE I
can be changed.
The center is the normal speed. Turning the knob toward +(-)
increases (decreases) the tape speed, plus or minus 10%
compared with the normal speed.
... If a Dolby NR encoded tape is played back with Pitch
Control, the sound may not be reproduced properly.
Continuous Playback Operation
Tape I
Side A Start
Side B Start
Tape II
Side A Start
Side B Start

Continuous Playback

1. Load pre-recorded cassette tapes in TAPE I and TAPE ll
2. Select the appropriate DOLBY NR system.
3. Set the REV MODE switch to the
CONT PLAY ( ä ) position.
4. Press the Ó or Á button of the deck
to be played back first.
5. Tapes will be played back continuously. See the chart
below;
... To stop continuous play before the tapes are played back 5
times, press the STOP button of either deck.
1. When playback starts in the forward
direction, at the end of Side A, the tape is
reversed to play the other side, Side B.
At the end of Side B, TAPE I is released.
If you start playback from Side B, TAPE I is
released at the end of Side B.
2. Control is transferred to TAPE Il, and
playback starts from Side A.
At the end of Side A, it is reversed and Side
B is played back.
3. At the end of Side B of TAPE II, control is
transferred back to TAPE l, and the
playback of Side A starts.
... TAPE I and II will be played back 5 times in
total, then this function will stop.
ï
Ë
ä
7