Swann ThumbCam DVR-415 Instrucciones De Uso página 7

Lens: The business-end of the camera, used to focus light on to the image sensor.
For best results, ensure the lens is clean and free from debris.
Mode Select: Changes the recording mode of the camera.
MicroSD Card Slot: The slot for inserting the microSD card which the ThumbCam
records to. To insert a card, simply push it into the slot. To remove it, push it in
again, and it will 'pop' right out.
Reset Button: Used to quickly return the ThumbCam to it's initial booted state.
This is typically used only if the ThumbCam freezes and needs to be reset.
Lanyard Clip: Used to attach the included lanyard. Alternately, it could be used to
attach the ThumbCam to just about anything - such as a key-chain or similar.
Power: Press to turn the ThumbCam on and off. Do not turn off the ThumbCam
whilst recording, or immediately after recording.
Record/Stop: Starts and stops the ThumbCam recordings.
Microphone: The device which records sound. If these holes are blocked, then the
range and quality of the audio recording will be significantly reduced.
LEDs: Small colored lights which will indicate the current state and function of the
ThumbCam. There are two LEDs, one red and one blue. In bright light (such as
sunlight) these might be difficult to see.
7 7