Disposal - Festool Symetric Manual De Instrucciones

The machine is equipped with self-disconnecting
special carbon brushes. If they are worn, power is
interrupted automatically and the machine comes
to a standstill.
• Clean the tabletop insert [1-9] regularly and
remove wood chips, dust deposits and workpiece
offcuts from the extraction channel on the chip
defl ector (see Fig. 6).
9.1 Replacing table insert
Never work with a worn table insert [1-9] but
replace it with a new one. To do this, release the
fi ve screws used to fasten the table insert on the
saw table.
A new table insert is supplied without a saw slot.
You will therefore fi rst have to saw a slot follow-
ing installation.
9.2 Adjusting the saw unit
The swivelling range of the saw unit can be read-
justed using the screw [6-2]. This may be neces-
sary if the diameter of the saw blade alters during
sharpening or if a new saw blade is fi tted.
– Set the sliding fence [6-4] to 0°.
– Release the lock nut [6-1].
– Swivel the saw unit downwards until it reaches
the fence.
– Adjust the saw unit by turning the screw [6-2]
as shown in illustration 7 (turn to the left - saw
unit is lowered; turn to the right - saw unit is
raised).
The saw unit must not be set so deep that
it can saw into the saw table.
– Tighten the lock nut again.
10 Accessories
Use only original Festool accessories and Festool
consumable material designed for this machine
because these components are designed spe-
cifi cally for the machine. Using accessories and
consumable material from other suppliers will
most likely affect the quality of your working
results and limit any warranty claims. Machine
wear or your own personal workload may increase
depending on the application. Protect yourself and
your machine, and preserve your warranty claims
by always using original Festool accessories and
Festool consumable material!
The order numbers of the accessories and tools
can be found in the Festool catalogue or on
the Internet under .
11

Disposal

Do not throw the power tool in your household
waste! Dispose of machines, accessories and
packaging at an environmentally-responsible
recycling centre. Observe the valid national regu-
lations.
EU only: In accordance with European Directive on
waste electrical and electronic equipment and im-
plementation in national law, used electric power
tools must be collected separately and handed in
for environmentally friendly recycling.
Information on REACh:
16