Problem Solving - Midland G11 Manual De Instrucciones

PRoBLeM SoLVING

Problem
The radio doesn't switch on
The radio switches off shortly after it has
been switched on
The battery pack does not recharge
The radio switches on but is unable to
receive signals
Noise is always present in reception mode The Monitor function is enabled.
It is not possible to communicate with
other parties
Reception is fragmented and/or disturbed
Transmission is not always possible
VOX causes the radio to accidentally
enable transmission
The VOX feature requires speaking in a
loud voice
The autonomy of the battery pack is limited Commission time is too high.
Logic related faults (unreadable displayed
symbols, functions blocked, etc.)
12
Possible Cause
The battery pack is discharged and/or has not been
installed correctly.
Discharged battery pack.
The battery-charger has not been connected or installed
correctly.
The site of installation is too shielded.
The volume is too low
Incorrect CTCSS or DCS
An incorrect radio channel has been selected.
The radio is installed in a shielded area or is too far from
the party you are communicating with
Incorrect CTCSS or DCS
The signal is very weak.
The transmission distance is excessive and/or there are
obstacles in the transmission path
Other parties are using the same channel
The radio has been installed too close to equipment that
causes interference (televisions, computers, etc.)
The channel is used by an excessive number of parties
or the transmission has been barred due to a busy
channel.
The sensitivity and/or environmental
noise is too high.
The sensitivity is too low.
Incorrect setting caused by a problem with the power
supply.
Solution
Verify that the battery pack is charged and that it has
been correctly installed.
Recharge the battery pack.
Inspect the connections of the battery-charger and the
installation of the batteries.
Move to an another area.
Adjust the volume level.
Check that the CTCSS tone or DCS code corresponds
to the one set by the parties you are communicating
with.
Disable the Monitor function.
Select the same radio channel used by the parties you
are communicating with.
Move to another area.
Check that the CTCSS tone or DCS code corresponds
to the one set by the parties you are communicating
with.
Try temporarily disabling the Squelch by means of the
Monitor feature.
Move closer to the party you are communicating with or
to another area.
Check the traffic on the radio channel by means of the
Monitorfeature and select another channel if required.
Increase the distance between the radio and this
equipment.
Select another channel. Ask the radio link provider to
disable the block due to busy channel.
Reduce the VOX sensitivity.
If the environmental noise is not high, increase the
sensitivity or use an optional microphone.
Try reducing the transmission time and/or using a low
power.
Recharge the battery pack