Bushnell HOLO Sight 510023 Manual De Instrucciones página 7

The elevation and windage adjustments are shown in Figure 3. For both elevation and windage,
each click will change the bullet's point of impact 1/2 Minute of Angle (MOA), which translates to
1/4 inch at 50 yards, 1/2 inch at 100 yards. Also, one full rotation of either knob will change your
point of impact 10 MOA. This translates into 5 inches at 50 yards, 10 inches at 100 yards. To move
the point of impact UP, turn the adjustment screw counterclockwise; to move the point of impact
DOWN, turn the adjustment screw clockwise.
Figure 3
To move the point of impact RIGHT, turn the adjustment screw clockwise; to move the point of
impact LEFT, turn the adjustment screw counterclockwise. The elevation and windage adjustments
have been initially set at the factory near the midpoint of their adjustment ranges and should be
close to being at zero with a properly installed mounting rail. Please do not turn the adjustments
before mounting the sight on the firearm. Be sure to check that the mount and the sight remain
secured after the first shots are fired.
CAUTION: When encountering a sudden increase in resistance in these adjustments, the end of
the adjustment range has been reached. DO NOT TRY to turn the adjustments any farther or
serious damage may occur to the sight.
LASER SAFETY ISSUES
The BUSHNELL HOLOsight is a Class II laser product. The Class II level illuminating beam,
however, is completely blocked by the housing. The only laser light accessible to the eye is the image
beam and is at a power level within the limit of a Class II laser product. The illuminating beam can
become accessible to the eye if the housing is broken. Turn the sight off immediately and return the
broken unit to the factory for repair.
2008 Holosight 510023+510023AP 6LIM rev3.indd 7
Elevation Windage
5
2/27/2008 11:07:22 AM