Setting Alarm - ECG R 500 Manual De Instrucciones

OPERATION
Turning the device on
• Set the device on a flat, stable surface, with controls easily accessible.
• Switch the device on by pressing and holding the button 1.
Charging the device:
• Connect to the device the cable with microUSB connector and the other end of the USB cable to
a computer or charger.
• Charging voltage: 5 V DC ±5%
• Charging time: 3 hours (500 mAh source)
Setting date and time
1. Switch on the device.
2. Press M to switch to the time mode, press briefly >II and select seting of year, month, day, hour and minute.
3. Press briefly I<< or >>I to change the value of the displayed data.
After you set minutes, end the setting of date and time by pressing >II.
4.
GB
Clock display mode
Press V- to switch between 12h and 24h time display format.
•

Setting alarm

1. Switch on the device.
Press M to switch to the time mode, hold the button >II to switch to alarm setting mode.
2.
3. Press I<< or >>I to set the hour of the alarm.
Press briefly >II to go to minutes setting.
4.
Press I<< or >>I to set the minutes of the alarm.
5.
After you set the required time of the alarm, end the setting by pressing >II.
6.
• When the alarm time is reached, the alarm sounds four times, always in five minutes interval. Switch off the
alarm by pressing any button.
• You can activate/deactivate the alarm, when you press and hold the button M in the time mode (when the
alarm is active, an alarm clock symbol appears in the top right corner of the display).
Modes description
USB mode and SD/TF card mode:
• When the device is in USB/SD/TF mode, you can play tracks in the MP3 format directly using the built-in
speaker.
Press V-/V+ to adjust the volume, control the playback using buttons I<<, >>I and >II .
•
FM radio mode
• First, plug in the AUX IN jack cable with 3.5mm connector, which serves as an antenna.
• Press the button M to switch to FM mode.
• Press >>II to search automatically for all accessible stations and store them in memory.
You can adjust volume by pressing V-/V+ , using I<< / >>I you move between the various FM stations.
•
• If you first switch to FM mode and then plug the cable into the AUX IN jack, the cable will not be recognized
as an antenna. You have to switch the device again into FM mode by pressing the button M .
AUX IN mode
• You can play music from external sources connected to the AUX IN connector. You can control the volume
using V-/V+.
AUX OUT mode
You can play music on an external device from this device using the connector AUX OUT or you can connect
headphones to this jack.
20