Standard Accessories; Maintenance And Inspection - Hitachi FDV 16VB2 Instrucciones De Manejo

English

STANDARD ACCESSORIES

In addition to the main unit (1), the package contains
the accessories listed in the below.
For entire area
(1) Side handle ..................................................................1
(2) Depth stopper ..............................................................1
For partial areas
(1) Chuck wrench ..............................................................1
(For drill chuck with chuck wrench)
(2) Plastic case ..................................................................1
Standard accessories are subject to change without notice.
APPLICATIONS
Rotation and impact function
○ Drilling holes in concrete, marble, granite, tile, and similar
materials.
Rotation only function
○ Drilling holes in metal, wood and plastic.
○ Tightening wood screws.
SPECIFICATIONS
Voltage*
Power input*
No load speed
Steel
Capacity Concrete
Wood
Weight (without cord)
* Be sure to check the nameplate on product as it is
subject to change by areas.
NOTE
Due to HITACHI's continuing program of research and
development, the specifi cations herein are subject to
change without prior notice.
MOUNTING AND OPERATION
Action
Fixing the side handle
Mounting and dismounting of the
bit*
Selecting rotation direction
Selecting the operating mode
Switching on and off and setting
the speed
Locking-on the On / Off switch
Releasing the On / Off switch
Selecting accessories
* Dismounting the bit
Firmly grasp the ring and loosen the sleeve by turning
it toward the left (in the counterclockwise direction as
viewed from the front) (See Fig. 2).
(110 V, 120 V, 127 V, 220 V,
230 V, 240 V)
550 W
0 – 2900 min
-1
13 mm
16 mm
25 mm
1.6 kg
Figure Page
1 99
2 99
3 99
4 99
5 100
6 100
7 100
– 101

MAINTENANCE AND INSPECTION

1. Inspection the drill bit
Continued use of a worn and/or damaged drill bit will
result in reduced drilling effi ciency and may seriously
overload the drill motor. Inspect the drill bit often and
replace it with a new bit as necessary.
2. Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that
they are properly tightened. Should any of the screws be
loose, retighten them immediately. Failure to do so could
result in serious hazard.
3. Maintenance of the motor
The motor unit winding is the very "heart" of the power
tool.
Exercise due care to ensure the winding does not
become damaged and/or wet with oil or water.
4. Servicing
Consult an authorized Service Center in the event of
power tool failure.
CAUTION
In the operation and maintenance of power tools, the
safety regulations and standards prescribed in each
country must be observed.
GUARANTEE
We guarantee Hitachi Power Tools in accordance with
statutory/country specifi c regulation. This guarantee does
not cover defects or damage due to misuse, abuse, or
normal wear and tear. In case of complaint, please send
the Power Tool, undismantled, with the GUARANTEE
CERTIFICATE found at the end of this Handling instruction,
to a Hitachi Authorized Service Center.
IMPORTANT
Correct connection of the plug
The wires of the main lead are coloured in accordance
with the following code:
Blue: — Neutral
Brown: — Live
As the colours of the wires in the main lead of this tool may
not correspond with the coloured markings identifying the
terminals in your plug proceed as follows:
The wire coloured blue must be connected to the terminal
marked with the letter N or coloured black. The wire
coloured brown must be connected to the terminal marked
with the letter L or coloured red. Neither core must be
connected to the earth terminal.
NOTE:
This requirement is provided according to BRITISH
STANDARD 2769: 1984.
Therefore, the letter code and colour code may not be
applicable to other markets except The United Kingdom.
4