General Use - Profi Care PC-LW 3028 Manual De Instrucciones

Set de rulos
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 15
Commissioning
• Check that the roller is fitted correctly.
• Switch the appliance on (I) or off (O) using the switch.
The heating phase has begun. The control lamp now
illuminates.
• Close the cover.
• Once the indicator lamp turns off, the curlers will be hot
and ready for use.
WARNING: Risk of scalding!
Always hold the curlers by using the outer handle area.
NOTE:
The temperature is controlled by a thermostat. The heat
switches back on automatically. The control lamp now
illuminates.

General Use

CAUTION:
• Only use the rollers on dry hair.
• Do not use the rollers on wigs or synthetic hair acces-
sories such as e.g. hair extensions.
• Place the appliance on a level, heat-resistant surface.
WARNING:
• Before cleaning remove the mains lead from the socked.
• Wait until the appliance has fully cooled!
• Under no circumstances should you immerse the appliance in
water for cleaning purposes. Otherwise this might result in an
electric shock or fire.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
• You can wipe the rollers with a lightly damped cloth.
• Clean the casing with a soft, dry cloth – without any
additional cleaning agents. If required you can lightly
dampen the cloth.
• Keep the inside of the appliance free of hair, dust or any
foreign objects.
PC-LW3028_IM
• Select the roller size depending on the length and style
of hair you want to have. For tight curls use small rollers;
for wavy hair use large rollers.
• To secure the roller there is a metal clip matching the
size of the roller.
• To retain the heat in the appliance, only open the cover
briefly to remove the roller.
• Take a part of the hair, comb it and wind it around the
roller. The lock of hair should not be wider than the roller.
• Secure your hair to the roller using a clip.
• Repeat the process with the other rollers.
• Switch the appliance off if you no longer need it. Pull out
the mains plug.
• Leave the rollers in your hair, until they have fully cooled
(around half an hour).
• Then remove the clips and unwind the rollers again.
• Remove any hair that has stuck to the roller, so that it
does not burn when the roller is next heated.
• Finally style the hair with your fingers. Do not use
brushes!
• Hold in place with spray or hair wax.
NOTE:
For better hold you can wash your hair before putting in
the rollers, apply mousse and blow dry.
CAUTION:
Do not apply styling products to the rollers!
Cleaning
• Make sure there are no metal clips on the base plate.
Use the accessory compartments to store the clips.
• Put the hair-curlers back into the storage box.
25
07.11.18

Publicidad

Tabla de contenido
loading

Tabla de contenido