Maintenance Advice; En - User Guide - NORAUTO 2010523 Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 11
Your Group 2-3 booster seat
(2)
1. Height adjustable head support
2. Diagonal belt guide (x2)
3. Back
4. Seat
In-car installation
Gr. 2-3, from 15 to 36 kg (from approximately 3 to 12 years)
Your car seat is fitted with an adjustable headrest that has been designed to support
your child throughout growth by providing maximum lateral protection.
Raise the adjustable headrest to its highest position (3). Place the car seat against the
back seat of the vehicle
(4)
and feed the diagonal strap of the belt through the headrest
guide (5). Sit your child in the car seat. The folding armrests make it easier to install
and access the car seat. Make sure that the child's back is fully in contact with the back
of the car seat. Pull and fasten the vehicle seat belt. Pass the diagonal strap of the belt
under the arm rest opposite the belt guide used. The waist strap of the belt passes un-
der both armrests (6). Lower the adjustable headrest and adjust it to the height of your
child (7). It should be positioned so that it surrounds your child's head, providing maxi-
mum lateral protection, whilst guiding the diagonal belt over the child's shoulder so
that it doesn't extend onto the child's neck
(8)
(9). Tighten the vehicle seat belt (10).
Make sure that the seat belt is properly tightened, that it is not twisted and that it is not
positioned at the level of your child's neck.
To remove your child from the car seat, simply unbuckle the seat belt and place it at the
side of the car seat. The belt will remain suspended from the headrest belt guide (11).
CAUTION: Before each journey, check that the armrests are lowered. Secure your car
seat with the vehicle seat belt at all times, even when your child is not in the car seat.
An unsecured car seat can cause injuries in the event of a collision.
Reclining your child seat
(12)
Storage of the instruction manual
(13)

Maintenance advice

All the material parts can be removed. Slight stains can be removed using a damp
sponge soaked in soapy water or it can be washed by hand at 30° in soapy water. Do
not use bleach, do not iron, do not machine wash, and do not tumble dry.
24

EN - User guide

Publicidad

Tabla de contenido
loading

Tabla de contenido