Overload Protection; Jump Starting; Compressor Operation; Battery Replacement - Carpoint 0177707 Manual De Instrucciones

The following table will give you an idea of what operation time you can expect when starting from a fully charged system:
Appliance type
Fluorescent lights, cell phones
Radios, fans, Depth finders
Camcorders. VCR's spotlights
Electric tools, bilge pumps
Electric coolers
Air compressors, car vacuums

OVERLOAD PROTECTION

Above 15A, overload protection cuts off power from 12V lighter socket. This will be restored after one minute when appliance is removed from 12V lighter socket.

JuMp startIng

For optimum performance, when using your jumpstarter to jump start a vehicle or boat, please read and follow these step-by-step instructions:
1. Connect the red (+) 'alligator' clamp to the red (+) positive battery terminal of the vehicle or boat.
2. Connect the black (-) 'alligator' clamp to a non-moving metal part of the engine, NOT to the (-) negative battery terminal.
3. Wait a minute or 2.
4. Switch the vehicle or boat engine ignition to 'start' for no more than 5 to 6 seconds.
5. If the vehicle or boat engine does not start, wait at least 3 minutes before trying again.
UNDER NO CIRCUMSTANCES ALLOW THE RED AND BLACk CLAMPS TO TOUCH EACH OTHER OR A COMMON CONDUCTOR.
1. Once the engine is running, disconnect the black (-) clamp first and return the cable to its stored position on jumpstarter.
2. Disconnect the red (+) clamp and return this cable to its stored position on the power booster.
3. As soon as possible, connect your jumpstarter system to the 230V AC adapter/charger and recharge.

coMpressor operatIon

Caution: Run compressor only for 10 minutes at a time continuously. Then leave off for 10 minutes before using again, so that compressor can cool off.
1. For tire inflation use the universal adapter that is attached permanently to the air hose. Place this adapter (no. C, see figure 2), onto the tire valve
system, press the adapter lever down to lock onto the valve system.
2. For inflation of leather balls, flotation devices, etc. use one of the plastic nozzles.
3. Check pressure gauge (No. A, see figure 2), determine the desired pressure.
4. Turn the power switch (No B. see figure 2).
5. When the desired pressure is reached turn the compressor switch (No. B, see figure 2) off.
6. Remove the adapter (No. C, see figure 2) from tire or other item being inflated.
Figure 3

BATTERY REPLACEMENT

Figure 3 shows a back view of your jumpstarter with the cover and eight screws removed. To replace the battery follow these steps.
1. Unscrew and remove the eight cross-headed screws at the back of your jumpstarter.
2. Lift off the cover plate to expose the battery compartment.
3. Unscrew the two cross-headed screws at the top of the battery.
4. Lift the battery out of the battery compartment.
Estimated power consumption (In watts)
4
9
15
24
48
80
12V DC Lead Acid Battery
Estimated usage time (In hours)
30
21
12
7
3
1,5