First Use; Checking The Callus Remover And Package Contents; Inserting Batteries; Operation - Silk’n AP-3WD Instrucciones De Uso

First use

Checking the callus remover and package contents

NOTE! Risk of damage!
Opening the packaging without due care with
a sharp knife or any other pointed objects may
easily damage the callus remover.
• Take great care when opening.
1. Take the callus remover out of the packaging.
2. Check whether all parts supplied are complete (see Fig. A).
3. Check whether the callus remover or individual parts are damaged. If this is the case,
do not use the callus remover. You should then contact the manufacturer at the service
address given on the warranty card.

Inserting batteries

1. Hold the callus remover horizontally.
2. Turn the battery compartment cover (7) anticlockwise and slide off.
3. If necessary, clean the contacts on the batteries and the device before inserting the batteries.
4. Upon insertion into the battery compartment (9), check for correct battery polarity.
5. Fit the battery compartment cover back on and turn clockwise to close tightly. You can
now insert a MicroPedi roller (2 or 8).

Operation

Selecting a MicroPedi roller
The callus remover comes with two MicroPedi rollers. Consult the following table to find out
which roller is suitable for which treatment purpose.
No. Colour
2 Light grey
8 Dark grey
With very rough skin, we recommend always using the dark-grey MicroPedi roller first, followed
by the light grey one.
Use
This surface of this MicroPedi roller is finer. Use this
MicroPedi roller to remove rough skin or for treat-
ment after using the dark-grey MicroPedi roller.
This surface of this MicroPedi roller is coarser. Use
this MicroPedi roller to remove very rough skin.
11
EN