Profi Care PC-FM 3027 Manual De Instrucciones página 24

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 15
• In the event that water escapes from the appliance, the appliance
may no longer be used.
• The appliance should only be filled with water. Do not use bath
oils, gels or other substances.
• Never sleep while using the appliance.
• Do not use the appliance for more than 20 minutes at a time.
• Sit down before putting your feet into the appliance. Never stand
up if your feet are still in the appliance.
• Do not use the appliance in the bath or the shower.
• Do not connect or disconnect the power plug while your feet are in
the water.
Health Instructions
• If you have any concerns about your health you should
consult your doctor before using the appliance for the
first time. This also applies to people with heart pace-
makers, diabetes or other diseases, pregnant women or
people with long-term muscle and / or joint pain. Continu-
ous pain may be a symptom of a serious disease.
• A massage should have a pleasant and relaxing effect. If
you feel discomfort or pain after a massage you should
consult a doctor before using the appliance again.
• Never use massage machines with open wounds, body
parts with circulation disorders, swellings, burns, inflam-
mations or skin sores or pus wounds.
Notes for Use
Location
Place the appliance on a dry, non-slip surface.
Line Cord
Do not push the line cord into the housing.
Operation
Dry Massage
The appliance can be used for a short time without water for
massaging the feet.
WARNING:
During the dry massage the appliance may only be oper-
ated in the "Massage" position 1.
24
PC-FM3027_IM
Wet Massage
WARNING:
Do not fill the appliance with hot water!
In order to enjoy a wet massage, fill the appliance with
warm water.
Footbath
1. Place the appliance on the floor so that you can sit
comfortably in front of it.
2. Make sure that the mains plug is not inserted before you
fill the appliance. Fill the appliance with cold or warm
water. Do not fill it over the maximum mark (see inner
wall (MAX)).
3. Only connect the appliance to a properly installed safety
socket.
4. Sit down and put your feet in the appliance.
5. Set the mode of operation. In order to do so please turn
the switch to the following settings:
0 Off
1 Massage
2 Heat + Whirl
3 Heat + Whirl + Massage
6. Enjoy a deep, penetrating massage by moving your feet
backwards and forwards over the reflex zone knobs.
7. For a specific foot reflexology, you can additionally use
the massage rolls.
NOTE:
The purpose of the heat generated by the appliance is not
exclusively for the warming of the water. It is generated to
avoid its rapid cooling.
27.03.18

Publicidad

Tabla de contenido
loading

Tabla de contenido