04. OPERATION
NOTE: Before using the appliance for the first time, switch it on for a few
minutes and allow it to run at the highest speed and temperature set-
ting. As a result of the manufacturing process, a slight odour may be
produced. This is not harmful and only occurs during initial use. Ensure
that the room has good ventilation.
Switching the appliance on/off and controlling the air flow
1. Insert the mains plug into an easily accessible socket.
2. The on/off switch and switch for the power settings 5 allow you to
switch the appliance on and to select the desired power setting:
0 – off
1 – slow air flow, lower temperature
2 – fast air flow, higher temperature
3. After drying, set the on/off switch to 0 (off) and pull out the mains
plug.
Ionic technology
This appliance features ionic technology, permanently releasing ions
onto the hair to reduce the static charge of the hair and allow easier
styling.
Selecting the temperature
The switch for the hot air settings allows you to select the desired
temperature for the air flow:
I = low temperature
II = medium temperature
III = high temperature
"COOL SHOT" cooling function
The hair section styled with hot air can be cooled to improve the dura-
bility of your hairstyle.
While drying your hair, press and release the 'COOL SHOT' button
●
●
to switch on the cooling function.
24
GB
A cool air flow is obtained, irrespective of the outlet temperature
(see Fig. B). To deactivate the cooling function, press the button again.
NOTE: If you do not switch off the cooling function – by pressing the
'COOL SHOT' button again – the function remains activated, also after
pulling the mains plug.
Styling nozzle
The styling nozzle makes it possible to target the air flow at specific
sections of hair.
Attach the styling nozzle to the front of the hair dryer so that it
●
●
clicks into place.
The styling nozzle can be rotated into any desired position.
●
●
You can remove the cooled styling nozzle from the hair dryer.
●
●
Diffuser
The diffuser distributes the air flow evenly over the hair and is particu-
larly suitable for curly or wavy hair.
Attach the diffuser to the front of the hair dryer so that it clicks into
●
●
place.
05. CLEANING
DANGER!
Before cleaning, pull out the mains plug and allow the
appliance to cool down.
CAUTION!
Do not use any harsh or abrasive cleaning agents.
Clean the appliance regularly. Be particularly sure to check that the air
inlet and air outlet are free from dust, hairs and fluff.
Wipe down the casing, the protective grille over the air inlet and
●
●
the styling nozzle with a slightly damp cloth.
GB
25