Kenwood TTP200 serie Manual De Instrucciones página 4

before plugging in
Make sure your electricity supply is
the same as the one shown on the
underside of your toaster.
WARNING: THIS APPLIANCE
MUST BE EARTHED.
This appliance conforms to EC
directive 2004/108/EC on
Electromagnetic Compatibility and
EC regulation no. 1935/2004 of
27/10/2004 on materials intended
for contact with food.
before using for the first time
1 Wrap excess cord around the cord
storage device on the underside of
the toaster
Operate the toaster once on a
medium setting without bread. (The
lever will not stay down unless the
toaster is plugged in).
As with all new heating elements,
your toaster may emit a slight
burning smell when it is first
switched on. This is normal and not
a cause for concern.
Use the carriage lever to lift the toast to
Peek & View™ at any time without
cancelling the toasting cycle.
key
warming rack selector
(TTP220/TTP230)
warming rack (TTP220 /TTP230)
Peek & View™ carriage lever
(with 'Hi-Rise™' for extra lift)
browning control
reheat button with indicator light
defrost button with indicator light
cancel button with indicator light
crumb tray
cord storage
.
to use your toaster
1 Plug the toaster into the power
supply.
2 Move the browning control to the
desired setting. Use a low setting
for light toasting and for thin or dry
bread.
3 Insert the bread, muffins, bagels etc.
4 Lower the lever
'cancel' button will illuminate. (The
lever will not stay down unless the
toaster is plugged in).
To toast frozen bread, once the
bread is lowered press the 'defrost'
button. The 'defrost' button will
illuminate.
To warm toast that's popped up but
gone cold, lower the toast then
press the 'reheat' button. The
'reheat' button will illuminate.
Use the carriage lever to lift the toast
to Peek & View™ at any time
without cancelling the toasting cycle.
To stop toasting during the cycle,
press the 'cancel' button, the toast
will pop up and the 'cancel' button
light will go off.
5 Your toast will pop up
automatically, to raise it higher, lift
the lever.
hints on using your
toaster
Select a lower setting for light
browning, for toasting one slice only
or for dry bread.
When toasting a single slice of
bread, you may notice a variation in
toast colour from one side to the
other - this is normal.
Dry/stale bread toasts more quickly
than fresh bread and thinly sliced
bread toasts more quickly than
thickly sliced bread. Therefore the
browning control should be set at a
lower setting than usual.
For best results ensure that the
bread slices are of an even
thickness, freshness and size.
4
until it locks. The