Samsung VRT PLUS WF520AB Manual De Instrucciones, Uso Y Mantenimiento página 36

troubleshooting
ERROR IMAGE
Water Temperature Control
Problem
Power Interruption
Water Supply Problem
A Button is either stuck or is
being pressed continuouly.
The Motor is not working
properly.
Temperature Sensor
Problem
High/Low Voltage Detected
Electronic Control Problem
Front MEMS Sensor Problem
Rear MEMS Sensor Problem
Excessive Suds
For any codes not listed above, call 1–800–726–7864 (1–800–SAMSUNG)
36_ troubleshooting
WF520AB-02838A_EN.indd 36
MEANING
The hot/cold water hose connection is
not correct.
Problem with control.
A fault is detected in the water level
sensor.
Jammed key.
Motor problem
Temperature sensor problem.
High/Low voltage detected.
Communication error between SUB
PBA and MAIN PBA
Front MEMS sensor problem
Rear MEMS sensor problem
Too many suds are detected during the
washing session.
The unit is put on hold until the suds
are reduced. Then, the unit will go back
to the operation.
When it finishes washing, "End" and
"Excessive Suds" codes will blink in
turn.
SOLUTION
Please connect the hot/cold water
hose connection correctly.
Call for service.
Call for service
Call for service
Restart the cycle
If the code reappears, call for service
Restart the cycle.
If the code reappears, call for service.
Restart the cycle.
If the code reappears, call for service.
Call for service
Call for service
Call for service
To prevent it, cut down on detergents.
2010-03-24 ¿ÀÈÄ 4:30:39