Publicidad
Installation Guide
(Please follow the related chapters to assemble)
1
1. Opening the Chassis
(SECC or Tempered Glass)
For SECC side panel, please remove the two thumb screws and lift up.
For Tempered Glass side panel, please remove by pressing the handle
on top of panel.
2. Power Supply Installation
Parts Required: PSU Screws.
Power supply can be mounted on the top bracket.
3. Motherboard Installation
Parts Required: Motherboard Stand-Off,
Motherboard Stand-Off Socket, Motherboard Screws
4. Expansion Card Installation
Parts Required: Screws,
Graphics Card Holder,
Graphics Card Holder Mylar
4
6-1
6-2
21
2
3
5. I/O Wires Installation
6-1. 2.5" Drive Bays Installation
Parts Required: 2.5" HDD Screws
6-2. 3.5" Drive Bays Installation
Parts Required: 3.5" HDD Screws
5
POWER LED
RESET SW
(Depend On Motherboard)
POWER SW
H.D.D LED
PORT2_L
BLUE
10
BROWN
SENSE2_R
9
SENSE_SEND
8
7
PURPLE
PORT2_R
5
6
WHITE
YELLOW
3
ORANGE
PORT1_R
RED
4
1 BLACK
PORT1_L
GREEN
2
HD Audio Header
LED Pipe Power Header
Ensure the beveled edge of the PSU connector is properly
aligned with the beveled edge of the LED light connector
PSU Connector
LED Light Connector
Red
Black
Black GDN
GND Black
12V Yellow
Black 12V
7
7. Fan / Liquid Cooling Radiator Installation
Parts Required: Fan Screws, Water-cooling System Washer
8
8. Bottom Fan Installation
Parts Required: Fan Screw
*Please remove the rubber foot stands,
and then loosen the screws on top.
Switch/LED Connector
POWER LED
RESET SW
POWER SW
USB2.0 Header
KEY
SNSE1_R
PRESENCE#
GND
USB3.0 Header
PIN#1
PIN#19
Vbus
1
IntA_P1_SSRX-
2
19 Vbus
IntA_P2_SSRX+
18 IntA_P2_SSRX-
3
GND
4
17 IntA_P2_SSRX+
IntA_P1_SSTX-
16 GND
5
IntA_P1_SSTX+
6
15 IntA_P2_SSTX-
GND
14 IntA_P2_SSTX+
7
IntA_P1_D-
8
13 GND
IntA_P1_D+
12 IntA_P2_D-
9
ID USBOC-
11 IntA_P2_D+
10
PIN#10
PIN#11
9
9. Completing Installation
Parts Required: Cable Ties
22
Publicidad
