CustomCool 21 Manual Del Propietario Y Manual De Instalación página 37

Turnthe Water On
Turn the water Oil at the shutoff valve.
Tighten any com_ection that leaks.
Replace the access cover and tighten all screws
(on some models).
Plug In the Refrigerator
Plug in the refl'igerator to the Power Outlet and
ttlrn
O/l.
IMPORTANT'Always
operate the Refl'igerator fl'om a
power source of the same Voltage, Frequency and
P,ating as indicated on the Refl'igerator
Identification Plate. Operate the Refl'igerator fl'om
an Earthed (Grotmded) 3 Pin Power Outlet flfllv
accessible when the refl'igerator is located in its
normal operating position.
Arrange the coil of tubing so that it does not
vibrate against the back of the refrigerator or
against the wall.
Push the refl'igerator back to the wall, making sure
the power cord and the water line tubing are not
trapped, entangled or squashed by the refl'igerator
(including the wheels) or wall.
Start the Icemaker
Set the icemaker power switch to the I position.
The icemaker will not begin to operate until it
reaches its operating temperature of-9°(: or below.
It will then begin operation automatically if the
icemaker power switch is in the I position.
NOTE: In lower water pressure conditions, the water
valve mav turn on up to 3 times to make sure
enough water reaches the icemaker.
37