Peaq PPA100BT-B Manual De Instrucciones página 28

27
Sources
BLUETOOTH SOURCES
1. The Bluetooth LED lit up in blue, and the
pairing sequence initiates after 10 seconds
with Bluetooth Sync LED blink between
red and blue colours rapidly. The Blue-
tooth mode is the default source selection.
Pairing sequence begins after 10 seconds.
The system will detect previous paired de-
vice within the first 10 seconds.
2. Pair with Bluetooth music devices (skip
this step if appliance remembered your
music device)
IPHONE, IPAD OR IPOD
Go to setting page from your advice (SET-
TINGS) > select GENERAL > enable BLUE-
TOOTH > select PPA100BT.
ANDROID PHONE
Go to setting page from your Android Phone
(SETTINGS) > select WIRELESS & NET-
WORKS > enable BLUETOOTH > select
PPA100BT.
OTHERS
Read the instruction manual came from
your device (enter the pairing code "0000"
if prompted).
NOTE: Paired successfully the Bluetooth
LED will blink once every 5 to 6 seconds.
WIRED SOURCES
Connect the playback device with the in-
cluded cable set (red, white) to the RCA in-
put interfaces.These are located at the rear
panel of the right speaker.
Press the SOURCE button and the Line IN
LED lit up.The system is now ready to re-
ceive audio via wired connection from your
media player.
ENGLISH