Unpacking The Appliance; Overview Of The Components / Scope Of Delivery; Notes For Use; Gap Nozzle And Brush Nozzle - Profi Cook PC-BS 3035 A Manual De Instrucciones

should check the state of charge after not more than a
month.

Unpacking the Appliance

1. Remove the appliance from its packaging.
2. Check the delivery scope for completeness.
3. Check the appliance for any transport damage, in order
to prevent hazards.
NOTE:
In case of any transport damage, contact your dealer
immediately. Do not use a damaged appliance!
4. Remove the transport locks on the two on / off switches.
Overview of the Components /
Scope of Delivery
Page 3
Figure
1 Dirt collection container
2 2-part filter insert
3 Indicator lights
4 Dust container release button
5 button (on / off switch on the basic unit)
6 Handle on the basic unit
7 Motor housing with air outlet
8 Suction opening
Figure
9 button (floor nozzle with lighting)
10 button (50 % suction power)
11 button (100 % suction power)
12 button (on / off switch for device with floor nozzle)
13 Sliding release for folding handle
14 Folding handle with appliance holder
15 Locking / unlocking for floor nozzle
16 Floor nozzle with turbo brush
17 Basic unit (refer to fig. )
18 Unlock button for the basic unit
Page 4
19 Charging station
20 Base
21 Socket for power adapter
22 Contact pins
23 Charging contacts
Not Shown
1 × Power adapter
1 × Gap nozzle
1 × Brush nozzle
38
PC-BS3035A_IM

Notes for Use

• The appliance is especially suitable for quickly vacuum-
ing small amounts of dry dirt or dust.
• The appliance is operated via charged battery. The bat-
tery is charged with the supplied charging station. Before
that, you must assemble the appliance and must hang it
into the charging station.
• Direct power supply via power adapter is not possible.
• This cordless vacuum cleaner is no adequate replace-
ment for a conventional floor vacuum cleaner. Especially
on shag-pile carpet, the cleaning performance is not
sufficient owing to its design.
• Contaminated filters reduce the suction power of the vac-
uum cleaner. Therefore, we recommend regular cleaning
of the existing dirt filters.
• Ideally, clean the filters whenever they were subject to a
prolonged use.
• Please regularly check and clean the electric floor
nozzle.
• If necessary, clean heavily soiled floors multiple times
and / or use a conventional 230 V~ floor vacuum cleaner.

Gap Nozzle and Brush Nozzle

• The nozzles are attached to the suction opening of the
basic unit.
• You may store the nozzles at the back of the charging
station.

Folding Handle

For back-friendly cleaning, the folding handle can be tilted
twice. This facilitates the vacuuming in hard to reach places
(e. g. under tables).
CAUTION:
• Do not tilt the folding handle beyond the respective
resistance. The appliance may be damaged otherwise!
• If you tilt the folding handle more than 90 °, the basic
unit will fall out of the appliance holder!
1. Pull the slider (13) upwards for a short time and tilt the
folding handle forward until resistance.
2. When pressing the slider again, you will be able to tilt the
folding handle a little more.

On / Off Switch (5 and 12)

The appliance comes with two on / off switches. Press the
or button to switch the appliance on or off.

Assembly and Battery Charging

Assembly of the Appliance

Refer to the illustrations on page 4.
A Place the supporting foot on a flat, stable surface. Plug
the charging station into the supporting foot. It must
engages.
18.04.19