Foppapedretti Eureka Manual De Instrucciones página 20

• ENGLISH •
ASSEMBLY
UNFOLD THE STROLLER
(fig.1, 2, 3)
CAUTION: make sure that the child, and any other children, are at a safe distance away when
carrying out this step.
The moving parts of the stroller must not for any reason come into contact with the child's body.
Move the closing lever "a", as shown in the figure (fig.1).
Lift the handlebar until the chassis opens completely. A click will indicate that is has been fastened.
Before using the stroller, make sure it is opened properly and the mechanisms are properly locked
(fig.3).
INSTALL FRONT WHEELS
Fitting the front wheels (fig. 4): Insert the end bushing into the slot situated in the center of the
wheel block.
A click will indicate that it is inserted correctly.
Check that both the wheels have been fastened correctly, if they are pulled downwards they should
not be released.
Move lever "a" outwards to block the swivel movement, and inwards to activate the swivel
movement (fig. 5).
Removing the front wheels (fig.5): Press the steel button "b" front wheel released.
INSTALL REAR WHEELS
(fig.5 a 13)
Refer to the kit instruction manual "REMOVING THE REAR WHEELS".
FASTENING THE SEAT
The seat can be mounted either in a forward-facing configuration (fig. 46) or facing the parent
(fig. 47).
Assembling the seat: Close up the seat against the backrest, as shown in the figure 6.
Check that both seat connectors (right and left side) are oriented in a vertical position and that the
symbols "- -" are aligned, this indicates that the connector is correctly oriented (fig. 7).
If the symbols are not aligned, manually rotate the external connector to correctly align the "- -"
symbols. If the connector is locked, lift up the backrest recline lever and at the same time rotate
the connector to align the symbols.
Line up and insert the plastic connectors of the seat in the slots provided on the pushchair chassis
(fig. 8). Press until a click is heard indicating that it has been fastened correctly (fig. 9).
To lower the seat into a horizontal position (fig. 10).
WARNING: Before use, always check that both the seat supports are fastened correctly to the
chassis. When the seat is lifted upwards, it must not detach from the chassis.
Removing the seat: adjust the footrest to a horizontal position. Adjust the backrest to a vertical
position, operating the recline lever (paragraph "Reclining the seat") and at the same time close
up the seat in contact with the backrest. Lift the seat to remove it from the frame (fig. 11, 12).
FITTING THE BUMPER BAR
Fitting the bumper bar (fig.13): line the bumper bar up with the slots and press on both sides. A
click indicates that it has been fastened correctly.
Removing the bumper bar (fig.14): press button A on both sides of the bumper bar and at the
same time pull to remove it.
Opening the bumper bar on just one side (fig.15): press button "A" on one side of the bumper
bar and pull to open it like a gate.
20