Maintenance And Cleaning - Foppapedretti Eureka Manual De Instrucciones

CLOSING THE CARRYCOT
13. Remove the cover.
14. Take out the inner mattress.
15. Unhook the Velcro and lift up the fabric along the side on the inside.
16. Grasp the belt and, pulling towards the inside of the carrycot, release the support bracket from the
clips and close it towards the inside of the carrycot. Repeat this process also on the second support bracket.
17. Place the handle in a horizontal position. Press on the upper ring to close the carrycot. Insert the
mattress inside the carrycot.
18. Place the cover on the frame and attach the press studs at the sides.
19. Press the plastic release button "A" and at the same time fold the hinge inwards.
20. Lock the folded hinge with the elastic band on the bottom. Repeat this process also with the second
hinge.

MAINTENANCE AND CLEANING

Check the carrycot regularly and make sure that there are no damaged or worn parts.
Replace the carrycot if there are damaged parts.
Lining
• The fabric parts can be washed following the instructions on the washing label.
• Clean the fabric with water, a mild soap and a sponge.
• Never use abrasive or ammonia, bleach or white spirit-based cleaning products.
• Clean the fabric with a brush rather than washing it.
• Do not store the product if it is still wet and do not leave it in humid environments since mildew may
form.
• Store the product in a dry place.
• Protect the product against weather agents, water, rain or snow; moreover, continuous and prolonged
exposure to sunlight can cause changes in the colour of many materials.
• It is recommended to wash the lining separately from other items.
• Follow the lining washing instructions on the labels.
• Dry the textile lining completely before using or storing it.
• To prevent formation of mildew, it is advisable to air the carrycot periodically.
Removing the fabric:
• Release the support brackets from the clips.
• Unhook the Velcro and lift up the fabric along the side on the inside.
• Detach the press studs along the top edge and remove the metal frame from the fabric.
• To remove the rigid bottom from the fabric, unscrew the screws with a tool and remove the support feet.
• Remove the panel from the fabric.
Replacing the fabric:
• If removed, insert the panel into the pocket on the fabric bottom and secure the 5 feet by tightening
the screws. Make sure that the panel is inserted correctly. The side with the clips further away from the
short side is the head side.
• Place the metal ring inside the fabric.
• Attach the press studs to the frame and fold the fabric, wrapping up the metal ring, from the outside
to the inside.
• Fold the fabric along the inner side and attach the Velcro on the bottom.
• Place the mattress inside the carrycot (fig. 17).
• ENGLISH •
MAINTENANCE AND CLEANING
13