Important Warnings - StreamLight VANTAGE II Instrucciones De Funcionamiento

Thank you for selecting the VANTAGE
As with any fine tool, reasonable care and maintenance of this product will provide
years of dependable service.
Please read this manual before using your VANTAGE
safety and operating instructions and should be saved.

IMPORTANT WARNINGS

BATTERY
WARNING: FIRE, EXPLOSION, BURN HAZARD.
USE ONLY: Streamlight, Panasonic or Sanyo size CR123A; Duracell 123A, or Energizer 123.
Use of other batteries or mixing of used and new or different brand batteries may result in
leakage, fire or explosion and serious personal injury. DO NOT recharge, misuse, short circuit,
improperly store or discard, disassemble, or heat above 212°F (100°C). Keep away from children.
USE ONLY THOSE BATTERIES SPECIFICALLY RECOMMENDED FOR USE IN THIS PRODUCT.
LED (VANTAGE II)
®
Caution - LED Radiation (RG-2)
Do Not Stare Into Beam.
May be harmful to eyes.
Per IEC 62471 Ed 1.0:2006-07
MOUNTING FIRE HELMET
1. Select the desired position above or below the helmet brim.
2. Loosen the clamp locking screw.
3. Slide the clamp assembly over the brim of
the helmet and rotate it to the desired position.
4. Tighten the locking screw until the VANTAGE
attached to the helmet using the hex key provided.
MOUNTING INDUSTRIAL MOUNT
1. Insert locking tab into hard hat.
2. Push locating tab until assembly securely clicks.
3. To remove, depress tab and pull light from helmet.
MOUNTING GALLET HELMET
1. Insert clamp in helmet slot until securely clicks
2. To remove, depress lock tab on helmet and slide rearwards.
NOTE: It is possible to remove mount assembly from
the "dove tail" slot by unscrewing the small set screw on
the dove tail plate. (Hex key not included)
II Series helmet-mounted LED flashlight.
®
®
II is securely
®
II, it includes important
CLAMP
LOCKING
SCREW
LOCKING
TAB
GALLET
CLAMP