Safety Regulations; Layout And Items Supplied - Bavaria BBC 52 Manual De Instrucciones

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.

1. Safety regulations

The corresponding safety information can be
found in the enclosed booklet.
Danger!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock, fi re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.
Safety devices
When working with the equipment, the appropri-
ate plastic guard hood for cutting blade mode or
cutting line mode must be fi tted to prevent objects
being thrown out by the equipment. The integra-
ted blade in the cutting line guard hood automati-
cally cuts the line to the optimum length.
Assembly: During assembly, take care not to let
any foreign bodies get inside the equipment or
the operation of the coupling will be impaired by
dirt.
After assembly: When the equipment is running
in idling mode, the tool is not allowed to rotate. If
this is not the case, an error was made during the
assembly work.
Explanation of the warning signs on the
equipment (Fig. 16):
1. Warning!
2. Read the directions for use before operating
the equipment.
3. Wear protective headgear, goggles and ear
muff s.
4. Wear sturdy, non-slip footwear.
5. Wear safety gloves.
6. Protect the equipment from rain and damp.
Anl_BBC_52_SPK7.indb 17 Anl_BBC_52_SPK7.indb 17
GB
7. Be careful of objects being thrown out!
8. Always switch off the equipment and pull out
the spark boot plug before carrying out any
maintenance work.
9. All bystanders must be kept at least 15 m
from the machine.
10. The equipment continues to rotate!
11. Caution: Hot equipment parts. Keep your dis-
tance.
12. Add a little grease (gear grease) after every
20 hours in operation!

2. Layout and items supplied

2.1 Layout (Fig. 1-2)
1. Long handle
2a. Steady grip on the right
2b. Steady grip on the left
3. Petrol tank
4. Starter cable
5. Air fi lter housing cover
6. Choke lever
7. Cable connection
8. Spark plug connector
9. ON/OFF switch
10. Throttle lever lock
11. Throttle lever
12. Throttle lock
13. Engine assembly
14. Long handle assembly
15. Harness
16. Line spool with cutting line
17. Thread cutter
18. 2x cable tie
19. Slotted screwdriver
20. Spark plug wrench
21. Allen key size 5 mm
22. Allen key size 4 mm
23. Oil/petrol mixing bottle
24. Cutting line guard
25. Top part of steady grip holder
26. Cutting blade guard hood
27. Cutting blade
28. 4x Allen screw M6x30, spring washer, washer
29. 4x Allen screw M5x25, spring washer, washer
30. 2x hex screw M6x16
31. 3x line cutter fastening screw (L = 10mm)
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
store where you made your purchase at the latest
- 17 -
13.01.16 08:15 13.01.16 08:15