Descargar Imprimir esta página

Petra WK 26.07 Instrucciones De Uso página 5

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 12
Instructions for use
GB
Before using
Read these instructions carefully.
They contain important notes for the
use, safety and maintenance of the
appliance. Keep them in a safe place
and transfer them to a possible
succeeding user. Only use the
appliance for the purpose mentioned
in these instructions. When using pay
particular attention to the
following safety advice.
Safety advice
• Connect the appliance to
alternating current only - with a
rated voltage according to the
rating plate - to a correctly installed
earthed socket. Cord and plug
have to be completely dry.
• Do not pull the connection cord
over sharp edges or jam it, do not
allow it to hang down and protect it
from heat and oil.
• Only use the kettle with the corre-
sponding base.
• Do not pull the plug by the cord
or touch it with wet hands.
• If the following happens do not
use the kettle respectively unplug it
immediately:
- the kettle or cord is damaged;
- the appliance leaks;
- any defect after a plunge or
something similar is suspected.
In these cases have the appliance
repaired.
• Do not place the boiler on hot sur-
faces, such as stove tops or such
or near an open gas flame, it may
melt.
• Make sure that the appliance is filled
up to the water level as boiling water
overflowing from the kettle could
damage surfaces.
• Do not use the appliance without
water.
• For filling the kettle remove it from
the base.
• Only fill the kettle with pure water,
not with milk, coffee etc.
• If the appliance is overfilled or ope-
rated with an open lid, boiling water
could splash out.
• During use do not move the
appliance and do not pull the cord.
• Caution:
The appliance will become hot
during use. Scalding danger due to
escaping steam! Only touch the hot
kettle by the handle and do not
open the lid when pouring out.
• Always empty the kettle completely
and do not leave remaining water
in the kettle for a long time.
• Keep out of reach from children.
• This appliance is not meant to be
used by persons (including child-
ren) with reduced physical, senso-
rial or mental capacities or in ab-
sence of the necessary experience
and/or knowledge - unless they are
supervised by a person responsible
for their safety and from whom they
get instructions on how to use the
appliance.
• Unplug in the following cases:
- faults during use
- before cleaning and
maintenance
. after use
• Do not immerse the kettle or base
in water.
• In case of misuse, wrong handling
or incorrect repair no liability will be
taken for possible damages.
Claims under guarantee are also
excluded in such cases.
• The appliance is not designed for
commercial purposes.
• Packaging material such as plastic
bags keep out of reach of children.
• In case the cord of this appliance is
damaged, it has to be replaced by
an authorised service agent of the
manufacturer or a person having
similar qualifications. Considerable
risks may be incurred by the user
due to improper repairs.
Putting into operation
Before first use clean the inside of
the kettle carefully. In order to do so,
open the lid by pressing the button
on the upper part of the handle. In
the spout there is a detachable sieve
that makes sure that calcium par-
ticles will be held back.
The length of the cord which is not
required can be rolled up at the bot-
tom of the base. Put the plug into an
earthed socket.
Fill with 0.5 liters of water, however,
only up to the max mark. Close the
lid until it snaps into the opening for
pouring. The automatic CookStop
only operates reliably by this method.
Put the kettle on the base in any
position you like. Only now press the
button below the.handle downwards,
the control lamp indicates that the
appliance starts to heat.
The button engages only if the
kettle is not on the base.
Because of the high power
consumption a higher noise level
during boiling is to be taken into
consideration. The water of the first
boilling process do not use for
preparation of food.
Automatic boil stop
Shortly after the water has started
boiling the automatic boil stop
switches off the appliance and the
control lamp extinguishes.
If there is only little water in the kettle
the boiling period until boil stop will
be extended.
If only warm water is desired, the
heating process can be stopped at
any time by pressing the button. The
automatic boil stop also works when
the kettle is lifted from the base.
If you want to boil hot water again
after some time the appliance can be
switched on once again.
Some condensate may drain on the
edge of the base on the bottom of the
5

Publicidad

loading